| Home · FAQ · New Posts · My Posts · PMs · Search · Members · Members Map · Groups · Profile · Donate ·
Log In
|
- You are currently viewing DISCO4.COM as a guest - Register to take part or Log In
Guineafowl21
Member Since: 03 May 2021
Location: Inverness
Posts: 12
  
|
| 2010 D4 upper tailgate intermittently not opening |
|
Hi all,
Popped over from LZ as I think we’re a bit stumped with this one:
As above, upper tailgate randomly won’t open, with no sound from actuator. There’s no pattern that I can spot.
GAP IID says:
1. The handle microswitch is working.
2. A pulse is always sent to the actuator; sometimes it doesn’t arrive.
3. Tailgate ajar sensor is working.
Keyfob button fails to open the tailgate as well during the fault. Sometimes two beeps come from the dash.
I have identified the power wire to the actuator, and traced it across the hinge and into the rear seat area. No breaks.
I have replaced the battery and done a hard reset.
From a search on here, it seems the body control module is in the passenger side fusebox, and sends the tailgate open signal out from a FET, underneath the seat and on to the back. No relay involved, as far as I can see.
I need to find out where the tailgate open signal is lost. Is it easier to find the relevant pin on the BCM, or go under the front passenger seat to find connector 3007/8?
Could there be a BCM fault which requires a re-flash?
Cheers
|
 3rd May 2021 12:29 pm |
|
|
philm
Member Since: 02 Oct 2016
Location: Manchester
Posts: 732
|
Actuator failing, do a search on this site. L633 Defender
Range Rover Velar-gone
Discovery 4 Landmark-gone
Gap IID Tool
|
| 3rd May 2021 1:07 pm |
|
|
Guineafowl21
Member Since: 03 May 2021
Location: Inverness
Posts: 12
|
Thanks, but as I say, no pulse arrives at the actuator during the fault.
|
| 3rd May 2021 6:08 pm |
|
|
Guineafowl21
Member Since: 03 May 2021
Location: Inverness
Posts: 12
|
philm wrote:Actuator failing, do a search on this site.
No joy after replacing the actuator, I’m afraid. Any other suggestions?
|
| 13th May 2021 12:24 pm |
|
|
Guineafowl21
Member Since: 03 May 2021
Location: Inverness
Posts: 12
|
Looks like I’m on my own with this one.
|
| 17th May 2021 10:45 am |
|
|
|
|
Guineafowl21
Member Since: 03 May 2021
Location: Inverness
Posts: 12
|
Thank you, but if you read my first post the tailgate switch signal is being received, according to GAP IID.
The actuator signal isn’t present at the connector under the front passenger seat, although the wiring from there to the actuator is intact, so it’s either the FET inside the BCM/CJB, or the wiring from it to the connector.
It looks like I need to remove the CJB.
|
| 17th May 2021 1:18 pm |
|
|
Gary_P
Member Since: 03 May 2016
Location: Kent
Posts: 1670
 
|
I can't comment on what might be causing your problem, but if you want infor on removing the CJB then search under passenger sunroof drain on this forum. There are quite a few helpful hints/videos posted on this.
Good luck with getting it sorted
Cheers Gary
-------------------------------------------
Discovery 4 HSE 2016MY
|
| 17th May 2021 5:10 pm |
|
|
Guineafowl21
Member Since: 03 May 2021
Location: Inverness
Posts: 12
|
Thanks - I’ll have a look.
|
| 18th May 2021 3:23 pm |
|
|
|
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
|
|
DISCO4.COM is independent and not affiliated to Land Rover.
