Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Technical (D3)

Air Suspension Connector Location and
Post Reply  Down to end
Page 2 of 2 <12
juanbass
 


Member Since: 17 Apr 2019
Location: red river, nm
Posts: 16

2008 LR3 4.4 V8 SE Auto Bonatti GreyLR3

Does anyone know what guage wire runs from Air Susp control module to the rear valve block? i'm not near my truck but cant find my new short and am just going to run new wire, need to buy today.

edit: Also, where I might source the metal wire end that goes into connectors C0867 and C0377

thx.
 ____________________________
2006 LR3 223,000 mi
2008 LR3 77,000 mi 
 
Post #209987815th Nov 2019 2:53 pm
View user's profile Send private message View poster's gallery Reply with quote
Pete K
 


Member Since: 15 Jan 2016
Location: GL
Posts: 10335

England 2005 Discovery 3 TDV6 HSE Auto Rimini RedDiscovery 3

guessing use 1mm or something,

Probably thicker than standard, but you want that if it's going to be external to the loom and flapping about

https://www.ebay.co.uk/itm/5-10M-coil-16-A...72lIT1tSPw



don't need a terminal. (they may have them in this sites shop)
otherwise just cut the wire a few inches away from the connector, and fit bullets, so you can connect up your new wire or the factory wire if you wish
  
Post #209990415th Nov 2019 4:31 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 2 of 2 <12
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site