Member Since: 03 Sep 2018
Location: Staffordshire
Posts: 567
Brake pad wear sensor clip
Hi,
I'd got a faulty wear sensor on my rear offside brake pads. I've fitted the new one and followed it back to where it connects, near the air suspension. The connector it plugs into has a dodgy clip so it doesn't actually hold that well and can just pull out/work itself loose. I tried another wear sensor and its the same so I know its the clip it connects too.
Does anyone know the part number for the wire the wear sensor wire joins and if it's an easy swap?
Cheers
Jim
11th Mar 2019 11:29 pm
lynalldiscovery
Member Since: 22 Dec 2009
Location: Maidstone
Posts: 7274
Small cable tie around the cable either side of the plugs then another cable tie looping the other two together thus holding the plug tightly sealed.
12th Mar 2019 8:01 am
jamez79
Member Since: 03 Sep 2018
Location: Staffordshire
Posts: 567
It's like you saw me do it.
Was wondering if the other cable is an easy replacement as I like things just so.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
