Take a look at the support section/ documents and you'll find the downloadable manual. It will show you that the tool is a very capable piece of kit.2011 MY D4 HSE
Previously 2001 D2 TD5, 1996 D1 300Tdi, 1985 90 2.2 petrol.
Bikes! KTM, BMW, British, Classics and others.
6th Jun 2019 8:59 pm
Tripe
Member Since: 28 Jun 2015
Location: Tasmania
Posts: 285
Re: Before I buy... cant it do??
QWERTY rrr
10th Jun 2019 10:40 am
Tripe
Member Since: 28 Jun 2015
Location: Tasmania
Posts: 285
I will try again
Can it also do:
Ecu remap: BAS only or Alive too? Yep, but you need to buy it
Egr patch: definitely remove the eml permanently? I think you need to pay for patch
Transfer box: reset/ calibrate ? It will Calibrate sensor position and clutches
Gearbox: reset / calibrate? It will Reset adaptions, need to purchase California stop
California stop?
Suspension: activate tight tolerance mode? Yes
Alter normal ride height? Not sure
Top Display: activate 4 wheel suspension screen ? Not sure
Update sat nav ?
Any other things it can do too would be interesting
Thanks[/quote]
10th Jun 2019 10:52 am
ajn9000
Member Since: 28 Jul 2019
Location: Cornwall
Posts: 6
Bardley wrote:
https://www.gap-diagnostic.com/
Take a look at the support section/ documents and you'll find the downloadable manual. It will show you that the tool is a very capable piece of kit.
Thanks very helpful
28th Jul 2019 10:16 am
Tripe
Member Since: 28 Jun 2015
Location: Tasmania
Posts: 285
I may be wrong on auto recalibration, if you buy a New GAP IId tool, i think it comes with the latest auto calibration.
I did the MY07 upgrade and when I checked the list of firmware for systems (print out/email) it showed I had the latest firmware for the automatic transmission.
29th Jul 2019 12:02 am
gstuart
Member Since: 21 Oct 2016
Location: kent
Posts: 14176
The California stop is when u slow down and then put ur foot back on the gas u can sometimes feel slack , the update helps to reduce it
Is a £25 software update through the gap iid fast lane service , pay online then u update ur iid via a laptop online, then load the software into ur disco
U can also adjust the normal ride height but the access and off road height will also be different , either lower or higher according to what u set ur normal ride height at
Hope that helps
29th Jul 2019 12:42 am
Tripe
Member Since: 28 Jun 2015
Location: Tasmania
Posts: 285
If you connect your GAP tool and press ECU info, and you find auto transmission and it says "latest version" then you have the latest software for auto transmission, paying $25 pound for the so called califiornan stop ECU flash, is a waste of time, as you have the latest.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
