err, after the ICP flash, the one-touch up doesn't work on the windows any more.
I tried the reset procedure, but no luck, so what now? --
2010 Defender Puma 90 + BAS remap + Alive IC + Slickshift + Ashcroft ATB rear
2015 Range Rover Sport V8 Supercharged
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 72785
7th Mar 2017 7:41 am
robpenrose
Member Since: 12 Jan 2016
Location: Surrey / SW London
Posts: 2136
Naks wrote:
err, after the ICP flash, the one-touch up doesn't work on the windows any more.
I tried the reset procedure, but no luck, so what now?
Which procedure are you trying?
Start at Top. All the way to bottom, let button go, then hold down for about 5-7 seconds
Then all the way to the top, let button go, hold up for 5-7 seconds.
Ive done this a few times and always worked??
Current: D4 HSE
Previous: BMW Z4M Coupe
Previous: Land Rover Defender 90 CSW Td5
Previous: Land Rover Discovery Td5 ES
7th Mar 2017 10:30 am
cosmic329
Member Since: 17 Dec 2013
Location: Chichester
Posts: 177
I had this also after a CCF update and it only worked once I had switched the engine off and the ignition only back on. Not sure that it normally needs this but worked for me.Discovery 4 SDV6 HSE '65 - Projects in planning phase!
ps. car was in for a 144-point check at the dealer, they sorted the one-touch up on the windows.--
2010 Defender Puma 90 + BAS remap + Alive IC + Slickshift + Ashcroft ATB rear
2015 Range Rover Sport V8 Supercharged
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 72785
robpenrose wrote:
It was easy for me mate. I just looked at the instructions and then let the IID do it all.
I didn't put mine on a charger, but I did check the battery state of charge and it was full. It only took a couple of minutes to full complete.
Looks a lot better, so worth doing
Just been out wielding my ECU flashing super powers, well the IID. Plucked up the courage and went out and did it. It's easy!! Just a little scary but if you just watch the ipad screen, don't look at the scary lights on the dash, and sit on your hands it's a piece of cake.
to Rob (for getting me to pluck up the courage) and Pat@GAP.
9th Mar 2017 1:48 pm
zinke
Member Since: 22 Feb 2014
Location: Scunthorpe
Posts: 584
Well I did it and all went well. Connected a second fully charged battery with jump leads just in case, had a steady 12.5v through the whole process. Looks much cleaner on the dash now.
Anybody know if you update the centre screen as well to give that a more modern look too?
Thanks.
Pete.IID, webasto software and workshop facility's available.
9th Mar 2017 10:14 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 72785
Just remembered and went out and reset the windows, simples.
10th Mar 2017 9:53 am
Merpher
Member Since: 12 Jun 2017
Location: Newport
Posts: 15
DSL wrote:
Will have to find the settings for heated seats, ar$e gets well fried if I don't knock it down to 2* pdq.
did you find the settings after an would you be able to post them on here so I can try thanks!
2nd Mar 2018 10:05 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 72785
I don't think I did find it, but was a long time ago. I just leave it on 3 until backside is suitably toasted then knock it down to 2.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum