Member Since: 23 Aug 2007
Location: Kent
Posts: 10564
wiggs wrote:
Russell wrote:
Disco_Mikey wrote:
Dealer tool is incapable of retro-fit/enable of timed climate, or RPH
Oh yes they can, my dealer activated it on my D4 previously with no issues what so ever
Dealers were given access to enable timed climate from about 2012 if my memory serves me correctly
Thats spot of Wiggs
I thought perhaps the issue is the fact that the unit was not fitted when they first tried to enable it but if they have tried since the unit was fitted then it blows that idea out the water.
Have you tried the re-programe the fob to the unit procedureMY17 D5 1st Edition Namib Orange
MY15 D4 HSE Kaikoura Stone
MY12 D4 HSE Nara Bronze Sold and gone
MY11 D4 HSE Stornaway Grey Sold and gone
D3 S spec Silver Sold and gone
Tow bar, full length roof bars, side steps, tow bar storage unit, surround camers.
D4 camera club
1st Feb 2016 8:50 pm
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
I was getting the correct green slow flash if I tried to activate but nothing fired up from the fbh so I guess I have answered my last question in that fob and receiver where still communicating.
All coming back to the car not being programmed when handed over despite them having it back a short while later to check why it wasn't functioning.
Will swop new for old one tomorrow - results will be interesting
1st Feb 2016 9:00 pm
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
Following on to previous post I have swapped the receiver for the 2010 model and the fob just gives a few rapid green flashes but the fob does not operate.
Refitted the new receiver and fbh fires up with the fob as expected.
Below photo shows the 2010 receiver on the left and new one to the right.
Click image to enlarge
2nd Feb 2016 8:55 am
Bodsy Site Sponsor
Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361
Did you re-pair the fob to the module? That's why it was giving the rapid green flashes.Bodsys Brake Bible
Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset See It Here
2nd Feb 2016 9:13 am
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
I was using both old receiver and old fob - how do you pair them please?
2nd Feb 2016 9:23 am
Bodsy Site Sponsor
Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361
Either disconnect the connector on the module, or remove the fuse in the engine bay (fuse 2 istr).
Then when you reconnect, hold the OFF button down and keep it held down for a few seconds.Bodsys Brake Bible
Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset See It Here
2nd Feb 2016 10:13 am
tintenter
Member Since: 29 Sep 2006
Location: Oldham
Posts: 1112
Are we saying the reciever on the left (T91R) wont work on a 2016 because i think that is what duckworths have supplied me if so i will have to get hold of Dan to discussTintenter
Corris Grey Discovery 4 HSE
Bigger permagrin now installed
Semper in excretum, sole profundum moveat.
2nd Feb 2016 10:55 am
Bodsy Site Sponsor
Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361
Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset See It Here
2nd Feb 2016 11:25 am
tintenter
Member Since: 29 Sep 2006
Location: Oldham
Posts: 1112
thanks Ian Tintenter
Corris Grey Discovery 4 HSE
Bigger permagrin now installed
Semper in excretum, sole profundum moveat.
2nd Feb 2016 11:32 am
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
Bodsy wrote:
Either disconnect the connector on the module, or remove the fuse in the engine bay (fuse 2 istr).
Then when you reconnect, hold the OFF button down and keep it held down for a few seconds.
Access to the receiver is easy so removed the power lead, re connected and held down the off button as you suggest. The fob still doesn't fire up the fbh. When pressing the on there are still around 5 rapid green flashes. When pressing the off there are around 5 rapid red flashes.
Refitted the new receiver and it works fine with its fob.
The part number for the new unit is VPLAX0061 - how does that number compare with your new one Tintenter?
2nd Feb 2016 1:41 pm
Bodsy Site Sponsor
Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361
LR036695 is the current receiver and is the AC version.
I have had quite a few of these and only had one faulty receiver that wouldn't pair, Dan swapped it no problem.Bodsys Brake Bible
Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset See It Here
2nd Feb 2016 1:50 pm
tintenter
Member Since: 29 Sep 2006
Location: Oldham
Posts: 1112
the box it came in quotes LR036695 and i beleive that it has paired just need to get it enabled in the ccf even tho i have the timed heatTintenter
Corris Grey Discovery 4 HSE
Bigger permagrin now installed
Semper in excretum, sole profundum moveat.
2nd Feb 2016 5:16 pm
tintenter
Member Since: 29 Sep 2006
Location: Oldham
Posts: 1112
ok following on from this i now have the msv2 sorted and communicationing with the D4 just need to know where i make the changes for the remote to be recognised any one willing to point me in the right directionTintenter
Corris Grey Discovery 4 HSE
Bigger permagrin now installed
Semper in excretum, sole profundum moveat.
3rd Feb 2016 1:46 pm
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14372
Timed climate
CCD
Heating & ventilation
Park heater- fitted
EUCD
Heating & ventilation
Additional heater - ffph
Callstart of parking heater - Callstart of parking heater .. Accessory only via radioG4 Gone ...but not forgotten
3rd Feb 2016 4:49 pm
tintenter
Member Since: 29 Sep 2006
Location: Oldham
Posts: 1112
thanks adrian will give it a go tomorrow just got back from meet at leagate Tintenter
Corris Grey Discovery 4 HSE
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
