Leej20
Member Since: 27 Apr 2019
Location: PO14 1LQ
Posts: 2
|
Hi, I know this may of been covered a million times, but thought I'd ask for my individual issue, I have a disco 3 hse 06, it's been dropping the front end over 2 days, starts fines no faults, levels itself back out when started, noticed on idle it can fluctuate about a little bit with self leveling, yesterday I drove around 150 miles with no faults, came out this morning and all 4 corners on their stops, started it up, fault on dash, plugged in with my scanner (latest snap on ethos), c1a03 nsf height sensor, now the question is... will that be causing my issue or will this be a red herring due to it being so low?? Any help or advice greatly appreciated, I've not tried the fuse test yet as not long had the vehicle. Dont really know where to go from here, dont want to chuck money at sensors if it's just a possibility?? Thanks.
|
19th May 2019 3:11 pm |
|
|
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10336
|
Humm.
Return it to normal height
Clear code
And rescan.
Monitor what happens over a few days
|
19th May 2019 4:22 pm |
|
|
Leej20
Member Since: 27 Apr 2019
Location: PO14 1LQ
Posts: 2
|
I've done exactly that, recalibrated the level sensors as the fault never returned once removed, will leave a few days and see what happens, if not I'll remove fuse and try that way. Going to be a time test.
|
19th May 2019 5:12 pm |
|
|