Member Since: 15 Sep 2012
Location: Gloucestershire
Posts: 94
Easiest method to remove height sensors when rusted?
Hi all.
Due to replace a couple of height sensors, but after a quick survey today, I have noticed the screws are hugely corroded. I cant even tell what head is on them!
What's the best method for removal? Dremel off the head?
Should be an easy job but I can tell already it will be a pain!
They are torx headed screws and can be a to get out, usually knock them from side to side and try to clean the head out from crap, but if all else fails then if you can get at the heads cut them off.
I think they are a torx 15 or 20..
Flack
31st Mar 2020 7:44 pm
MatcherMike
Member Since: 15 Sep 2012
Location: Gloucestershire
Posts: 94
Cheers flack.
Will give it a go. Dremel and drill bits by my side!
Mike
31st Mar 2020 9:35 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20727
Drill through the sensor body, aiming for the screws, if its rear sensors
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum