Pairing the remote "is done by connecting the connector and after approximately 2 seconds of connecting but within 6 seconds, press the OFF button on the transmitter for at least 1 second. Alternatively, if you have it all connected up, you can do it by pulling the fuel burning heater fuse in the engine bay for at least 5 seconds and then after refitting the fuse, after 2 seconds but within 6 seconds, press the OFF button on the transmitter for at least 1 second."
Above thread is a good reference for fitting FBH remote. Be good if it could be made a sticky by admins Discovery 4 HSE - Aintree Green
Freelander 2 TD4 SE Automatic - Tonga Green
Defender XS - Tonga Green - Gone Now
Freelander 1 Td4 ES Manual - Epsom Green - Gone Now
Freelander 1 Td4 Kalahari SE - Epsom Green - Gone Now
Freelander 1 XEi - Epsom Green - Gone Now
Member Since: 12 Oct 2009
Location: worcestershire
Posts: 295
Thanks for your reply Martin, any advice on how to check the loom and power there etc? How do I check if the coolant pump is faulty?
Does it just bolt onto the FBH or part of it?
Regards
24th Jan 2023 4:53 pm
Martin Site Admin and Owner
Member Since: 06 Nov 2004
Location: Hook Norton
Posts: 18563
Coolant pump is external to the FBH, attached on the side of the FBH mounting bracket.
It's the part on the cooling circuit after the little upside down "U" shaped coolant hose.
On a D4 there's a 2 pin plug on the pump and a 3 pin plug on the FBH. Check this loom for damage (or being unplugged) first.06 D3 SE / 15 LR D90 XS SW / 88 LR 90 Td5 / 68 BMW 2000 ti
Any issues with the site let me know!
24th Jan 2023 5:07 pm
disco32009
Member Since: 12 Oct 2009
Location: worcestershire
Posts: 295
Ok perfect, I will do some testing and will let you know.
Much appreciated for all your help and advise
Regards
24th Jan 2023 5:33 pm
disco32009
Member Since: 12 Oct 2009
Location: worcestershire
Posts: 295
Hi Martin,
I have tested the coolant pump and I cannot seem to get any life out of it.
I have tested the loom and that is fine.
When I clear the code and retry the FBH the code then reappears after you have started the FBH.
And the same code appears.
Regards
24th Jan 2023 7:51 pm
Martin Site Admin and Owner
Member Since: 06 Nov 2004
Location: Hook Norton
Posts: 18563
How did you test it?06 D3 SE / 15 LR D90 XS SW / 88 LR 90 Td5 / 68 BMW 2000 ti
Any issues with the site let me know!
24th Jan 2023 9:25 pm
disco32009
Member Since: 12 Oct 2009
Location: worcestershire
Posts: 295
I did a continuity test on the loom from the FBH to the coolant pump.
And I put 12v to the coolant pump and couldn’t get anything from it.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
