Matt R
Member Since: 04 May 2010
Location: Hants
Posts: 49
  
|
Hoping someone can help me with some advice regarding addition of remote.
I already had the timed function enabled, and tonight fitted the aerial and receiver.
I 'think' it's paired ok, but when I try switching on, the green LED flashes but nothing happens in the car.
The flashing matches the correct 'on' message in the T91 manual, so now I'm a bit confused..
1. Does the CCF need additional editing for remote, over and above activating timer ?
2. Shouldn't the remote be flashing red instead of green ? Tried pressing on and off together but nothing happens - no lights at all..? Guess this isn't switchable on LR as the car knows when to heat or vent, but is green ok??
3. Cold outside, so didn't bother unfurling aerial and attaching, but presume if the remote says its made contact then that won't matter ?
Any advice appreciated
Thanks
Matt
|
 24th Nov 2014 9:48 pm |
|
|
geoff.
Member Since: 24 Jan 2010
Location: West kent
Posts: 8531
|
needs the ccd editing in both ccd and eucd 
|
| 24th Nov 2014 9:49 pm |
|
|
Matt R
Member Since: 04 May 2010
Location: Hants
Posts: 49
|
Thanks Geoff
Any answers to the other two questions ?
For LR applications does it just flash green for 'on' and red for 'off' or does it change for venting vs heating ?
Cheers
Matt
|
| 26th Nov 2014 10:33 pm |
|
|
northernmonkeyjones
Member Since: 11 Feb 2013
Location: Derby
Posts: 64
|
yep, did mine on the D4 a couple of weeks back, or should i say a local indy did it for me, needed programming. it is possible for any indy with autologic to do it or someone with multi vehicle versions of fault mate or IID.
leaving the aerial furled will reduce the range, but if the green light is flashing it is talking to the receiver ok. Its not been warm enough for it to vent so have never seen it flash red yet, am assuming it always flashes green.
|
| 27th Nov 2014 10:55 pm |
|
|
