Member Since: 18 Apr 2019
Location: Herefordshire
Posts: 153
Fitting the tow bar holder (LR020002)
I picked up one of the LR020002 foam/metal tow bar holders this week from eBay and I've just finished fitting it.
Thankfully this forum had the instructions as it was a bit of a pain in the backside to fit.
As has previously been mentioned, you don't need to remove the side panel, seatbelts etc.
I started trimming the carpet myself before realising it was already perforated in the places I was cutting.
It was a bit of a squeeze in the D4 as there seems to be so much wiring blocking the bracket from sliding into place, however I used the old screwdriver in the two holes trick to lever it into position.
Next stop, fitting the 13 pin electrics.
[Updated with photo of install]
2003 Freelander Commercial 2.0 TD4 (Oslo Blue) SOLD
2013 Range Rover Vogue SE 3.0 TVD6 (Luxor Gold) SOLD
2013 Discovery 4 HSE 3.0 SDV6 (Aintree Green) SOLD
Made in Japan since 2022
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
