Member Since: 11 Mar 2016
Location: Canberra
Posts: 2
Front not going up
Hello all, I was driving my 2006 2.7 diesel to the coast, it was over 40 deg day, (Im in Australia)
went up a steep hill, gearbox threw a fault , went all stupid , which it does now and again, but then the suspension went to the bump stops. stopped for a while, then by using the raise control the back would come up ok but the front won't raise, compressor gave the over heating warning, since then i have fitted a new front valve block, no difference, when i had the valve block off ,using my shed compressor, i could pump up both front springs ok, and if i started the motor heaps of air was common down the line to the valve block, tried a disconnect battery reset, it has a new compressor fitted a month ago.
any ideas appreciated, thx Pete
22nd Jan 2019 12:12 am
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 4657
You need to have the codes read Pete, otherwise its just a guessing game. Does sound like the heat may have precipitated your troubles though.yµ (idµ - eAµ) ψ=mψ
22nd Jan 2019 12:24 am
Petey
Member Since: 11 Mar 2016
Location: Canberra
Posts: 2
was trying to avoid that, but looks like the only way, will post s reply when i get the solution, thx
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
