Winch RAI rock sliders roof rack rear ladder to name but a few Home of RLD Hidden winch mounts Spare wheel Locks Trailer Body Fabrication ray@rld-tech.co.uk D3/4 sump plates MY 14 sump plates and the Discovery Sport wheel protectors Discovery 5 wheel locks
more Helsport tents and other things for camping Law of Mechanical Repair:
"After your hands are coated with grease, your nose will begin to itch and you'll have to pee!"
30th Jul 2008 1:43 pm
chesters
Member Since: 03 Oct 2005
Location: The Toon
Posts: 698
Done 9 k miles on my AT2's and they have been great. Good grip and lasting well. Arctic Frost Discovery 3 TDV6 SE, Active Rear Diff, Adaptive Head Lights, Tow Pack, Ebony Leather, Roof Rails, Mantec Guard. Tasmod Stainless Sill plates. Grabber AT's. Home made mud flaps. Side Steps back on until the next time.
30th Jul 2008 3:47 pm
AJS4X4
Member Since: 30 Mar 2008
Location: Surrey
Posts: 3224
Tim,
Many thanks for your business, was nice to meet you today.
Pleased you are happy with the General AT2's, I think you will find these to be (IMHO) the best all-round tyre available at present to suit the D3 on 18" wheels.
Member Since: 09 Jun 2007
Location: Cape Town
Posts: 340
I had the bush settling/alignment/uneven tyre wear issue and replaced the Wranglers with AT2's. I have been very happy, but at 5000km there is a wear pattern on the outside of the front tyres that is not smooth or flat but is angled on each tread lug. Is this normal?
19th Aug 2008 8:52 am
Bushwanderer
Member Since: 27 Nov 2007
Location: Northern Rivers, NSW, Australia
Posts: 2050
Hi Andrew,
No, this is not normal. It is scrubbing due to poor alignment.
Did you get the 4-wheel alignment done when you fitted the new tyres?
20th Aug 2008 5:42 am
AJS4X4
Member Since: 30 Mar 2008
Location: Surrey
Posts: 3224
You would also get this if you drive hard in corners and roundabouts, mind you I mean hard.
Member Since: 09 Jun 2007
Location: Cape Town
Posts: 340
Hi Bushwanderer.
Yes, I had the alignment done in geometric mode at the same time that I put 4 new Grabbers on. I must say though, I don't percieve any pull to the left or right. Can I have the alignment checked without being in geometric mode?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Law of Mechanical Repair:
