Member Since: 09 Nov 2015
Location: WirralCh479sf
Posts: 12
High Pressure rail sensor location and installation
Just bought a high pressure rail sensor but it’s not on the side as stated on youtube 🤪
so on checking my manual it says in the event of a faulty high pressure rail sensor the whole sensor and rail should be replaced, I can’t find the pressure sensor on the right rail bank , however there is a similar looking sensor at the back near the bulk head , was there a modification to the sensor location?
on youtube you can see the sensor on the end of the pressure rail clear as day
11th Jun 2024 5:16 pm
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 5042
The sensor location differs between 04 to 06 MY and 07 onwards. Early models have it located in the centre of the passenger side fuel rail, whereas with 07> it's located at the end of the same rail just behind the EGR motor. yµ (idµ - eAµ) ψ=mψ
11th Jun 2024 6:34 pm
Scissors
Member Since: 09 Nov 2015
Location: WirralCh479sf
Posts: 12
Thanks for that , I have located sensor , it is in the middle near the bulk head / fire wall
there is a separate small rail that supplies the 2 main rails either side
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
