Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > IIDTool Help

HVAC Heat/Cool Learn Actuator Limits Stepper motor init
Post Reply  Down to end
Page 1 of 1
Lee-Howdle
 


Member Since: 20 Aug 2019
Location: Stafford
Posts: 13

United Kingdom 2006 Discovery 3 TDV6 Base 7 Seat Auto Zambezi SilverDiscovery 3
HVAC Heat/Cool Learn Actuator Limits Stepper motor init

Where do I find these programs within the system on the IID app as I have read the manual but can't seem to find it anywhere within the app any help will be greatly appreciated

I've replaced a couple of the motors but can't seem to clear the fault B1B77-00 for the front right air blend stepper actuator.

4.7.10 HVAC Heat / Cool

Learn Actuator Limits L322-10, L319-10, L320-10)
This routine is used when an actuator is removed or replaced. It is also required when the HVAC ECU
is replaced.

Stepper motor initialisation (L319-10, L320-10, L405, L494)
This routine is used when a stepper motor is removed or replaced. It is also required when the HVAC
ECU is replaced.
 I now have a IID tool if anyone needs some assistance around the Stafford area.  
Post #214012621st Apr 2020 1:17 pm
View user's profile Send private message View poster's gallery Reply with quote
lynalldiscovery
 


Member Since: 22 Dec 2009
Location: Maidstone
Posts: 7274

United Kingdom 2006 Discovery 3 TDV6 Metropolis LE Auto Bonatti GreyDiscovery 3

Isnt there a self test thing you can do on the unit itself, ie press xy buttons for so long and it does the test?
  
Post #214014621st Apr 2020 3:05 pm
View user's profile Send private message View poster's gallery Reply with quote
Lee-Howdle
 


Member Since: 20 Aug 2019
Location: Stafford
Posts: 13

United Kingdom 2006 Discovery 3 TDV6 Base 7 Seat Auto Zambezi SilverDiscovery 3

Yes I tried the Econ and recirculation button which run through it self test. I’m starting to lean towards A wiring harness fault. I have tested all the buttons and they appear to be functioning correctly through the IID. I’ve got the motors out and I’m testing them whilst not fitted in place it seems like the driver-side blend motor is only receiving a signal from the passenger-side blend motor, Due to the fact that they cannot operate too far out of sync i.e. the driver-side motor is only moving a small amount When operating the passenger-side temperature switch through its full range and still only moving a small amount when operating the drivers side temperature switch through its full range.
that’s all I can think of Confused
 I now have a IID tool if anyone needs some assistance around the Stafford area.  
Post #214015521st Apr 2020 3:46 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site