Member Since: 10 Oct 2016
Location: Brisbane
Posts: 23
IID Help!
Hi all from the colonies .
I have a recently purchased a GAP IID BT tool and so far am happy, although I am still learning.
So, I fiddled with the EAS heights recently, lowering all corners by 10 mm to ensure clearance under my building.
But then I fiddled some more, and some more and some more......
Whilst no problems were caused, I've now forgotten where I'm at, height wise.
Is there a 'reset to factory' option?
I've read the manual and can't quite put on a finger on it.
I've a 2006 D3 TDV6.
Cheers
RalphNow D3 2.7 TDV6 06
Then D2 TD5 99
Then D1 V8 96
Then S3 2.4 76
15th Dec 2017 11:39 pm
tayaste
Member Since: 15 May 2013
Location: Chester
Posts: 7633
It will have saved your first height when first plugged in. Just restore it.
15th Dec 2017 11:47 pm
Ralph1malph
Member Since: 10 Oct 2016
Location: Brisbane
Posts: 23
Cheers, I'll try thatNow D3 2.7 TDV6 06
Then D2 TD5 99
Then D1 V8 96
Then S3 2.4 76
15th Dec 2017 11:56 pm
Steve916
Member Since: 13 Aug 2017
Location: Northants
Posts: 69
You could follow the procedure for recalibrating your suspension heights, in case it was out to start with. It’s step by step on the iid tool.
16th Dec 2017 12:11 pm
annette
Member Since: 16 Dec 2017
Location: Tilarán
Posts: 66
In doubt go out and measure and fiddle till you are @ 790mm in the wheelarches.
OR
set everything to 200 in the GAP tool and start over
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum