Nitromad
Member Since: 31 Jan 2024
Location: Oxfordshire
Posts: 2
  
|
| iid tool ecu error read problem |
|
hi all
I've been using my idd tools for a few months without problems but now I am having trouble trying to read ecu errors....it won't the app or device get stuck on "scanning modules". the only way to recover is to force close the app then I get the following "Your tool is currently in a state that cannot be recovered from, disconnect from OBD port and try again"
this works but if I try to read faults it gets stuck at "scanning modules" again.
does anyone have any ideas ?
thanks
Gavin
|
 21st Mar 2024 2:17 pm |
|
|
grzesiul
Member Since: 11 May 2008
Location: UK
Posts: 6415
  
|
i had similar issues and found that pushing tool into the OBD port too far causes connectivity issues
Greg
|
| 21st Mar 2024 3:05 pm |
|
|
Nitromad
Member Since: 31 Jan 2024
Location: Oxfordshire
Posts: 2
|
did a hard reset and reader working again
|
| 21st Mar 2024 3:31 pm |
|
|
Flack
Member Since: 06 Sep 2006
Location: Preston Lancashire
Posts: 6312
 
|
The pins get spread out on the OBD socket over time, check to make sure its not that.
Flack 
|
| 22nd Mar 2024 1:51 pm |
|
|
