Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > IIDTool Help

L320 Suspension calibration driving me MAD
Post Reply  Down to end
Page 1 of 1
lamb190
 


Member Since: 14 Nov 2015
Location: bristol
Posts: 46

United Kingdom 
L320 Suspension calibration driving me MAD

Ive got the new software on my IID tool which is easy to use.

For some reason my L320 seems to sit abit low on the front and 15-20mm heigh on the rear.

I adjust the calibration to 461/465 as per tool and its sets height. I click on apply, then as soon as i drive it down the road it says raising suspension on dash and goes to about 480mm on the rear! Wtf. Ive gone through this time and time again. No change.

Can anyone help?

Ive tryed to just adjust the rear height cant seem to go lower - just higher!

Cheers

Spencer
  
Post #196370715th Jul 2018 5:50 pm
View user's profile Send private message View poster's gallery Reply with quote
tayaste
 


Member Since: 15 May 2013
Location: Chester
Posts: 7633

United Kingdom 2008 Discovery 3 TDV6 HSE Auto Stornoway GreyDiscovery 3

Sensors ok?
   
Post #196370815th Jul 2018 5:52 pm
View user's profile Send private message View poster's gallery Reply with quote
lamb190
 


Member Since: 14 Nov 2015
Location: bristol
Posts: 46

United Kingdom 

I dont think i have any sensor errors?

The suspension heigh button works (all heights change)
  
Post #196371515th Jul 2018 6:01 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site