Member Since: 15 Jan 2016
Location: GL
Posts: 10683
I thought it was a 2006/2007 thing.
2nd Oct 2021 1:20 pm
sarumlight
Member Since: 06 Nov 2008
Location: Off the Plain
Posts: 1592
Might've been. I'm sad enough to try and find an old brochure now lol
2nd Oct 2021 1:23 pm
R1wilky
Member Since: 15 Sep 2021
Location: Durham
Posts: 93
No gray plug and it’s a 05 hse I’m robbing the bits off.
I can’t remember when I had seats out fitting sat nav if there was a plug under the driver’s carpet under the seat.
If not is it just a case of getting the loom and plugging it in on the driver’s kick panel.
And when I fit the logic7 amp will I need to tell the ccf it’s fitted or will it just work.
2nd Oct 2021 1:52 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10683
Dunno, sorry
So I reckon, to fit a drivers memory seat, without doing the mirrors, you need to do the following wire connections on the grey plug.
Thick brown/green to + 12v pin 13 to fuse 46. (you may already have this wire under the seat on the ford connector)
Thick black to ground (there should be a thick black wire on the ford connector, you can use)
Thin black to ground pin 12.
white/red to +12v pin 11 to fuse 54
red pin 22 to LIN BUS (this is diffciult to find) Should be on the windscreen pillar as it runs to the sunroof and rain sensor). There is likly more than 1 red wire though! Start on the drivers side pillar
All other cables on the grey connector. (lots) are for the mirrors and mirror switch
Of course, if you get the floor loom out the HSE with the grey plug, it should be easier and simpler. But those wire above and what you need to pay attention to
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
