Powderpuff
Member Since: 05 Nov 2009
Location: Rugby / Beauly
Posts: 140
|
I want to remove the carpet section of the lower tailgate so that I can drill it to fit some press-stub popper bases which can then be attached my load liner, that way when you close the tailgate the liner won't fall down on the inside.
Is there and easy way to take this trim panel out?
|
 14th Feb 2010 4:38 pm |
|
|
Powderpuff
Member Since: 05 Nov 2009
Location: Rugby / Beauly
Posts: 140
|
Anybody?
|
| 15th Feb 2010 10:27 pm |
|
|
Windy Corner
Member Since: 23 Feb 2009
Location: South Leicestershire
Posts: 484
  
|
G,
Have a look here
http://www.disco3.co.uk/forum/topic30050.h...lgate+trim
Don't know whether that helps ?
I have seen another post somewhere which uses some butter knives to esxtract the trim, but can I find it ?????
Rik Discovery 4 HSE SDV6 Baltic Blue
Discovery 3 S TDV6 Zambezi Silver - Now gone........
Leicestershire & Rutland 4x4 Response
|
| 15th Feb 2010 10:55 pm |
|
|
|
|
Powderpuff
Member Since: 05 Nov 2009
Location: Rugby / Beauly
Posts: 140
|
Rik,
Cheers...I bow to your superior skills with the site search engine!
Looking at those threads I might just be able to drill a few holes in the carpeted board and put a 7 style popper base on with a rivet without need to actually remove the panel....doesn't look like I'd be drilling into the wiring harness or anything important.....
G
|
| 15th Feb 2010 11:06 pm |
|
|
|
|
Powderpuff
Member Since: 05 Nov 2009
Location: Rugby / Beauly
Posts: 140
|
My load liner is large enough to cover the rear tailgate so just needs to be secured in place at the top to stop it falling down when the tailgate is shut....problem with having 2 Golden Retrievers in the back is that Velco will just get pulled off I suspect.
|
| 16th Feb 2010 4:15 pm |
|
|
