Member Since: 08 Oct 2009
Location: BRISTOL
Posts: 97
Mine's Broke. Is yours?
I removed my battery cover today and found this cable holder type thingy damaged Obviously looks like it should be fixed to the nut and bolt above. It must of been broken and forced backwards when the battery was installed at the factory. Although to me it looks like there is no room for it to be where it should be when the battery is in situ.
Please could somebody have a look at their car and see if it's where it should be.
Many thanks
9th Feb 2010 11:30 pm
FISHY
Member Since: 08 Oct 2009
Location: BRISTOL
Posts: 97
Just checked another D4 and the holder is in place on the nut but it was quite bowed and looked like it would break with any force. Basically a very bad design
12th Feb 2010 3:05 pm
FISHY
Member Since: 08 Oct 2009
Location: BRISTOL
Posts: 97
Please, please can somebody else have a quick look under their battery cover to see if theirs is broken, its only takes a moment. I'm just trying to build a case to get mine changed under warranty. I have been told its a 10-12 hour job to change
9th Mar 2010 12:33 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73090
Doesn't matter how long it takes, if it was broken during manufacture it should be fixed under warranty. Getting a battery into a D3 is a tight fit I should imaging same for a facelifted D3 (some call it a D4). Obviously more peeps have this problem the less LR can wriggle & say "You must have broken it".
PS does that fixing being broken result in the battery box not being secured properly??
If you look at Fishy's he's also got tape wraped around it, just not as much - looks like they used the tape to keep the wires in place in the middle of the holder.
But I agree, Fishy, you need to insist they repair at their cost - I mean, you wouldn't have removed the battery yourself anyway would you
9th Mar 2010 1:06 pm
Q86ARR
Member Since: 23 Feb 2010
Location: Jersey
Posts: 379
They started adding extra tape there on D4s as CAN wires were getting trapped under the nut.
9th Mar 2010 6:39 pm
Bill Wright
Member Since: 03 Nov 2007
Location: Glorious Devon
Posts: 3254
Just checked mine. It's intact and is wrapped in insulating tape. Gave it a good shove and it does not appear to be cracked or broken.
Bill WrightNever take life too seriously. Nobody gets out alive anyway.
D4 SDV6 SE Tech Kaikoura Stone MY15.
9th Mar 2010 7:07 pm
Russell
Member Since: 23 Aug 2007
Location: Kent
Posts: 10564
Mines fine and has no tape on it.MY17 D5 1st Edition Namib Orange
MY15 D4 HSE Kaikoura Stone
MY12 D4 HSE Nara Bronze Sold and gone
MY11 D4 HSE Stornaway Grey Sold and gone
D3 S spec Silver Sold and gone
Tow bar, full length roof bars, side steps, tow bar storage unit, surround camers.
D4 camera club
9th Mar 2010 8:13 pm
FISHY
Member Since: 08 Oct 2009
Location: BRISTOL
Posts: 97
Many thanks for checking chaps
As you said Mr H I haven't had any cause to remove the battery. I will get it to the dealer asap.
Thanks again
DSL the fixing being broken doesn't affect the battery box it appears to just hold the wiring harness.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Obviously looks like it should be fixed to the nut and bolt above. It must of been broken and forced backwards when the battery was installed at the factory. Although to me it looks like there is no room for it to be where it should be when the battery is in situ.
I'm just trying to build a case to get mine changed under warranty. I have been told its a 10-12 hour job to change 
