| Home · FAQ · New Posts · My Posts · PMs · Search · Members · Members Map · Groups · Profile · Donate ·
Log In
|
- You are currently viewing DISCO4.COM as a guest - Register to take part or Log In
jonjo6782
Member Since: 08 Nov 2022
Location: ireland
Posts: 4
  
|
| Non starter after handbrake module replacement |
|
Got the handbrake module replaced in my discovery 3 recently, once fitted the vehicle won't start, it is flickering the immobiliser light, an e displayed in the gear indicator (manual) and the hazard lights are flashing. The vehicle has lost communication with the ecu and handbrake module. I have tried plugging the old one back in still no joy. Any ideas???
|
 17th Nov 2022 10:45 pm |
|
|
Flatlander
Member Since: 20 Jul 2015
Location: Here
Posts: 575
|
Are the fuses OK? is the bale arm connector latched in properly? all the symptoms you describe are loss of CAN communication to and through the park brake module.
|
| 17th Nov 2022 10:55 pm |
|
|
jonjo6782
Member Since: 08 Nov 2022
Location: ireland
Posts: 4
|
All fuses checked and are OK, would the new module cause a short circuit and blow the ecu?
|
| 18th Nov 2022 10:47 am |
|
|
Flatlander
Member Since: 20 Jul 2015
Location: Here
Posts: 575
|
I've never known it, if there was a short circuit, then a fuse would have blown, if the data lines were somehow shorted, the other connected modules would shut down and recover when the old module was reconnected - you haven't left anything unplugged around the centre console when removing and fitting the release cable have you?
|
| 18th Nov 2022 11:00 am |
|
|
jonjo6782
Member Since: 08 Nov 2022
Location: ireland
Posts: 4
|
Turns out I plugged the old handbrake module back in and the vehicle started, new one must be a faulty
|
| 18th Nov 2022 6:09 pm |
|
|
Flatlander
Member Since: 20 Jul 2015
Location: Here
Posts: 575
|
Or it could be a D4 module, they operate at different CAN speeds....
The CAN identifier size is different, not the speed.
|
| 18th Nov 2022 6:19 pm |
|
|
Flack
Member Since: 06 Sep 2006
Location: Preston Lancashire
Posts: 6232
 
|
Have you tried to re-sync the ecu's the epb module is one that is checked for ID before starting.
Flack 
|
| 19th Nov 2022 8:00 am |
|
|
jonjo6782
Member Since: 08 Nov 2022
Location: ireland
Posts: 4
|
There was no communication with either the epb module or the ecu when it's plugged in
|
| 19th Nov 2022 9:47 am |
|
|
|
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
|
|
DISCO4.COM is independent and not affiliated to Land Rover.
