Member Since: 23 Sep 2019
Location: Richmond
Posts: 117
Sorry I finally remembered.
I had a terminal brain injury 4 years ago, so my memory is difficult to operate.
29th Sep 2022 9:00 pm
johnhorgan
Member Since: 23 Sep 2019
Location: Richmond
Posts: 117
You have to copy the link, then open another page then paste and search to see the graph.
30th Sep 2022 12:21 am
Flatlander
Member Since: 20 Jul 2015
Location: Here
Posts: 575
That doesn't work mate, the link will work for you because the file is on your PC
30th Sep 2022 7:30 am
johnhorgan
Member Since: 23 Sep 2019
Location: Richmond
Posts: 117
Click image to enlarge
30th Sep 2022 8:48 pm
johnhorgan
Member Since: 23 Sep 2019
Location: Richmond
Posts: 117
30th Sep 2022 9:01 pm
johnhorgan
Member Since: 23 Sep 2019
Location: Richmond
Posts: 117
Click image to enlarge
30th Sep 2022 9:33 pm
johnhorgan
Member Since: 23 Sep 2019
Location: Richmond
Posts: 117
The exhaust pipe has been converted to a straight through pipe, with the catalytic converter removed by the previous owner. Do you think that could confuse the sensors enough to throw a fault code ?
30th Sep 2022 9:37 pm
Flatlander
Member Since: 20 Jul 2015
Location: Here
Posts: 575
Honestly, I'm not sure. the back-pressure (or lack of it) shouldn't affect the boost pressure, it will allow the turbo to spool up quicker - which could potentially lead to over-boost but that doesn't seem to be your problem.
The graphs are quite difficult to read - the last composite one is a good resolution but my eyes have difficulty distinguishing between some of the colours - there are a couple of anomalies though, one at 48 & the other at 64. I'm not sure what would cause them - it's not the 'unstick' process the ECM runs if it detects no change in boost and high actuator current, it's too short for that.
you could try blocking one side of the exhaust with a drain bung to increase the back-pressure and see if it makes a difference, whether positive or negative. As you say, the DTC was active with your last turbo which had a seal failure, now whether that was the cause of the DTC or a symptom - or even unrelated, solving that riddle will put you (us) in the right direction...
30th Sep 2022 10:11 pm
johnhorgan
Member Since: 23 Sep 2019
Location: Richmond
Posts: 117
The 2 graph lines dropping at 64 are boost pressure adjustment bank 1 and boost pressure adjustment full PID.
Maybe they are to stop manifold pressure going too high.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
