Member Since: 19 Feb 2008
Location: Boksburg
Posts: 800
MacLeod 313,
I would sugest you try and find one of these, drills from
4-22 mm in steps, sheet metal to plastic. A very use full tool for doing
D3 mods.
D3 bullbar-spots-roof rack with spots-ladder-long range tank-swing out spare wheel carrier- upgraded tow bar-dash console-internal water tank-duel awnings-drawer system & T T.
3rd Dec 2008 8:46 am
TallPaul
Member Since: 03 Jan 2008
Location: Near Reading
Posts: 1214
If you want a "reamer" like discoeast suggests, RS sell them... (www.rswww.com)
3rd Dec 2008 12:29 pm
MacLeod 313
Member Since: 18 Apr 2008
Location: away
Posts: 10723
I like new tools, the reamer looks 8) , I will look into it, thanks guys.
Just one more SMALLISH question, will I have to relocate my (uncle Ray supplied) CB ariel bracket. It is right at the furthest point back on the rails, it cant go further back so hopefully wont interfer with the expo going on.
And this was the previous bracket from XTC, but the new one is almost in the same position, but right back to the end trim
3rd Dec 2008 10:20 pm
SN
Member Since: 03 Jan 2006
Location: Romiley
Posts: 13710
Think you might be unlucky mate - the rack butts right up to that little plastic lug at the rear
Steve N | 21MY Defender | 08MY Discovery 3 (history) | 06MY Discovery 3 (ancient history)
4th Dec 2008 12:59 am
DG Site Moderator
Member Since: 12 Dec 2005
Location: The Gaff
Posts: 50944
...but you can just transfer the bracket onto the rack slot 21 year LR veteran > D2 GS 2003 > D3 S 2006 > D3 HSE 2009 > D4 HSE 2013 > D4 HSE 2015 > D5 HSE 2018 > DS HSE R-Dynamic P300e 2021
4th Dec 2008 1:05 am
MacLeod 313
Member Since: 18 Apr 2008
Location: away
Posts: 10723
DG, are the rack slots similar to the rail slots then? Maybe a daft question to people, but I canny check and trying to overt probs, and trying not to undo work already done.
4th Dec 2008 6:34 am
DiscoStu
Member Since: 09 Apr 2006
Location: London
Posts: 11412
Member Since: 18 Apr 2008
Location: away
Posts: 10723
Great that's a relief. Had visions of undoing previous CB work, or and emergency call to Ray for a solution. Much apprecited mate.
4th Dec 2008 8:03 am
MacLeod 313
Member Since: 18 Apr 2008
Location: away
Posts: 10723
Might even be an oportunity to centralise the bracket too. Ray's brackets are brilliant, but cos the rails on the HSE aint dead level, they lean out a little, the ariel does'nt sit upright.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum