Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Maintenance & Mods (D4)

Question about detachable towbar seating?
Post Reply  Down to end
Page 1 of 1
D3puty Dog
 


Member Since: 15 Aug 2011
Location: Derbyshire
Posts: 139

United Kingdom 2007 Discovery 3 TDV6 SE Auto Java BlackDiscovery 3
Question about detachable towbar seating?

I have 2013 D4 that I have just bought a refurbed Land Rover detachable tow bar and have a query because I'm not sure it's seating properly. The tow bar operates ok, it retracts the large tit and extends the small one as per, however when you push it up the orifice it seems to go all the way up but the large tit that should secure it does not reach, or seat into the slot that appears to be there for it, is it the wrong bit of kit, or is it OK, trawled the forum. can't see anyone who's had this before, any help really appreciated.
 Its all in the grip of the Tyre Fitters hand!  
Post #23705886th Jun 2024 5:29 pm
View user's profile Send private message View poster's gallery Reply with quote
Gareth
Site Moderator 


Member Since: 07 Dec 2004
Location: Bramhall
Posts: 26774

United Kingdom 

Make sure the hole and the towbar are clean. Apply a little grease to the surfaces, and make sure you push it in hard. Get a mallet and give a few hits to make sure it’s seated. If you can’t see any red on the handle markings, and you can turn and extract the key, it’s probably ok.
  
Post #23705916th Jun 2024 5:50 pm
View user's profile Send private message View poster's gallery Reply with quote
D3puty Dog
 


Member Since: 15 Aug 2011
Location: Derbyshire
Posts: 139

United Kingdom 2007 Discovery 3 TDV6 SE Auto Java BlackDiscovery 3

Thanks for that, I can turn and extract the key ok, but why is the hole there if it's not to be used to accept the larger spring loaded , shaped bar? I'll have it off again tomorrow and look again, I did smear sone copper slip on the surfaces before inserting. Thanks again!
 Its all in the grip of the Tyre Fitters hand!  
Post #23705926th Jun 2024 6:02 pm
View user's profile Send private message View poster's gallery Reply with quote
HairyFool
 


Member Since: 04 Jan 2023
Location: North Essex
Posts: 683

United Kingdom 2016 Discovery 4 3.0 SDV6 Landmark LE Auto ZanzibarDiscovery 4

Off the car pushing the small pin In should make lock flick round and the D shaped pin fly out. The green handle should not turn any further and the key comes out. Reset the lock.

Clean the mating surfaces of rust and only wipe a thin film of oil on them. Line up a slide the hook up firmly and the lock handle should flick round again. A small amount of twist to set the lock home to remove the key easily is acceptable but a lot or you can’t get the key out means it is not seated.

Do not leave in the towbar when not in use. That way you are checking it every time you use it.
 A visitor from the dark side, my other vehicle is an is still an EV. Strictly speaking its SWMBO.  
Post #23706006th Jun 2024 7:15 pm
View user's profile Send private message View poster's gallery Reply with quote
MrTed
 


Member Since: 06 Jan 2023
Location: Rickmansworth
Posts: 192

United Kingdom 2015 Discovery 4 3.0 SDV6 HSE Auto Santorini BlackDiscovery 4

I used this video when I brought my 2nd hand one which was a bit rusty: ?si=Jtw0aP4wWOI-VRy0
 Discovery 4 HSE late 2015 Euro6
Jaguar XF Portfolio (PX'd for above)
Mitsubishi Galant V6 (PX'd for above)
Instagram: @mrtedgfx 
 
Post #23706357th Jun 2024 8:43 am
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site