Member Since: 09 Sep 2015
Location: Somerset burnham on sea
Posts: 359
Rear spoiler fitment
Hi, can anyone confirm for me if this will defenatly fit (or not) a D4 facelift 2014
2015MY discovery 4 se tech with factory black pack.
With added
Rse, tv, electric memory seats, rear camera, heated steering wheel,
Headlight dip assist, remote FBH, led door light pack,easy lift kit,osram front fog/drl/active cornering lights. and whatever els I can find to do,
24th Jun 2019 5:59 pm
disco5
Member Since: 23 Dec 2012
Location: birmingham
Posts: 1088
yes it will fit any year d3 or d4 ...
I would get some one to fit it for you as you will not pick up a hammer and smash your brake light to bits to get it out ....its really hard plastic just watch the electrics and the rear water pipe for the wiper..once you have a whole get a stanley with long blades and start cutting away , its got tonns and tonns of windscreen silicon , the curved sections are hard i used my mates air saw to cut and trim away sections at a time as well,
24th Jun 2019 8:08 pm
Gilly1
Member Since: 09 Sep 2015
Location: Somerset burnham on sea
Posts: 359
Hi disco5, thanks for your response. Yes iv been reading what a nightmare the brake light is to remove.
Hopefully I won’t need a whole tailgate by time finished. 2015MY discovery 4 se tech with factory black pack.
With added
Rse, tv, electric memory seats, rear camera, heated steering wheel,
Headlight dip assist, remote FBH, led door light pack,easy lift kit,osram front fog/drl/active cornering lights. and whatever els I can find to do,
24th Jun 2019 8:14 pm
LT
Member Since: 31 Dec 2005
Location: South West
Posts: 23366
I’ve never known what it’s meant to do!
Good luck fitting it though. 2006 D3 HSE (Original & still the best)-GONE
2010 D4 HSE (A bit bling)-GONE
2014 D4 HSE (Almost too bling)-GONE
2015 D4 HSE (A heated what?)-GONE
2016 D4 Landmark (Written Off)-GONE
2016 D4 Landmark (Surely the last!) PD1881 rims-GONE
2017 FFRR SDV8 Autobiography
24th Jun 2019 8:21 pm
disco5
Member Since: 23 Dec 2012
Location: birmingham
Posts: 1088
once you've got a hole it a bit easier (its broke ) till then its your pride n joy lol.
A grinder will do the job easy just cut around once you can see whats there hour max to cut out 2man job fitting and couple hrs to let it go off with tape holding it in place .
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
