Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Maintenance & Mods (D3)

Removal of inner door panel on D3
Post Reply  Down to end
Page 1 of 1
les996
 


Member Since: 15 Sep 2009
Location: Bedford
Posts: 78

United Kingdom 2005 Discovery 3 TDV6 S Auto Zermatt SilverDiscovery 3
Removal of inner door panel on D3

Hi all

I put a post up earlier in the week about removing the inner door panel to find and sort an annoying rattle...

Got v.quick response from BBS SPY:

"2 long screws towards the bottom, another under the airbag badge and one under a small plate behind the door open handle, Then you need to remove the cover off the door pull, it has some holes underneath you are supposed to use to free the two upper barbs but i never used them, just pulled it up while wiggling it till the barbs unclipped.
There are 4 screws under that, then pull the panel towards you with some force as there are a lot of clips around the edge. Watch out for teh one at the top of the tweeter bit. You could help with a flat lever but as you are against the painted metal you want to be careful not to scratch it.

When the panel comes away the cable for teh door open can be releaded by unclipping the barb and allowing it to lever out. when putting back be sure the roller at the cable end engages in the slot for it, of course there are a few electrical plugs of which the door switch ones are quite tight.

hope this helps"

...thing is, I have removed the screws at the bottom, and the screw behind the door pull (and pulled that out), but how does the airbag cover come away - and am I being too soft whit this as there is no movement whatsover with the panel yet???

sorry if I am missing soething, probably being over cautious Confused

Thanks in advance Les Smile
  
Post #53619518th Oct 2009 3:25 pm
View user's profile Send private message View poster's gallery Reply with quote
wiggs
 


Member Since: 03 Sep 2006
Location: Manchester
Posts: 14368

United Kingdom 2015 Discovery 4 3.0 SDV6 HSE Auto Fuji WhiteDiscovery 4

Just get a small screwdriver behind it ( use a cloth near the edge so it dosent scratch the trim )..just pops out
 G4 Gone ...but not forgotten  
Post #53619818th Oct 2009 3:41 pm
View user's profile Send private message View poster's gallery Reply with quote
DiscoDunc
 


Member Since: 08 May 2006
Location: Bristol
Posts: 16390

England 2010 Discovery 4 3.0 SDV6 HSE Auto Aintree GreenDiscovery 4

This might help - Ive just replaced my door mirror

http://www.disco3.co.uk/gallery/albums/use...cement.pdf
 Duncan
-----------------------------------------------------
If I'd known I was going to be so thirsty this morning I'd have drunk more beer last night.
FFRR Autobiography 4.4 SDV8 MY17
D4 HSE MY13 SOLD
FFRR 3.6 Vogue TDV8 SOLD
D4 HSE MY10 SOLD
D4 SE TECH MY15 SOLD
D4 XS MY12 SOLD
D4 HSE MY10 SOLD
D3 HSE MY06 - Re-Cycled Worldwide 
 
Post #54285630th Oct 2009 8:57 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site