Member Since: 18 Apr 2011
Location: Kent
Posts: 87
Replaced coolant expansion tank and car failed on highway
OK so had the coolant sensor fault on the expansion tank and did the replacement today.
Unfortunately allot of coolant came out in the process falling over what would seem to be the alternator / aircon unit?
Anyhow, after the re-re all was fine car drove fine for about 20 miles and then motor died completely - not mechanical dead - electrical dead. Came to a stop ignition turns on. As soon as you try and crank the car there is the slightest of clicks and then almost as if there is a short as all the electrics then reboot. Its almost as if the starter motor is shorting out - but would have expected the starter motor to be further back in the engine bay - also why would a shorted starter motor kill the car while driving on the highway?
Battery is perfect - I thought maybe alternator got wet was not charging and battery drained to nothing and car died - but nope battery is in good health.
I ran a quick scan of codes on the car and there was some issue on a "current control module" - cant recall exactly what - but sounds like it could be the issue.
Member Since: 18 Apr 2011
Location: Kent
Posts: 87
Gawd bloody hope it will!
Will see in the mornin
29th Jan 2022 10:24 pm
popsdosh
Member Since: 09 Nov 2009
Location: cambs
Posts: 442
Flack wrote:
Try turning the crank by hand to see if it moves.
Flack
+1 was it preceded with vibration.
30th Jan 2022 9:28 am
stevebez
Member Since: 18 Apr 2011
Location: Kent
Posts: 87
Hi all...
Pleased to report engine turns freely... scanned codes and there are a raft of electrical ones ? My suspicion is the generator control module
... brace for this as there are a few...
B1087 LIN bus A
P0671 Cylinder 1 glow plug - circuit open
P0672 Cylinder 2 glow plug - circuit open
P0A1A Generator control module
C0063 Yaw rate sensor
B100D Column lock authorisation
U0102 Lost communication with transfer case control module
U0121 Lost communication with ABS control module
U0128 Lost communication with parking brake control module
U0132 Lost communication with ride level control module
U0136 Lost communication with differential control module - rear
U0138 Lost communication with all terrain control module
U0214 Lost communication with remote function actuation
U0241 Lost communication with headlamp control module A
U0264 Lost communication with the rear camera module
U2013 Switchpack
U0166 Lost communication with auxiliary heater control module
U0416 Invalid data received from vehicle dynamics control module
U3003 Battery voltage [this is very strange battery is 100% and fully charged]
B1D65 Right headlamp swiveling motor circuit
B1D64 Left headlamp swiveling motor circuit
U0402 Invalid data from transmission control module
U0422 Invalid data from the body control module
U0415 Invalid data received from ABS control module
So looks like a comms short / module failure to me?
I'd hazard a guess all the U codes are, as you thought, a loss of electrics. Can you clear all faults and see which come back?.
Dean
====================================
2011 D4 XS - OBD port protection, RLD spare wheel protector, All LED interiors lights, Timed Climate enabled, iiD tool paired.
2011 D4 Landmark - Stolen from same dealer before I paid for it
2011 D4 GS - Stolen whilst at dealer ... All LED interiors lights, DRLs, Spare Wheel protector.
1996 300Tdi - Eaten by tin worms
30th Jan 2022 11:52 am
stevebez
Member Since: 18 Apr 2011
Location: Kent
Posts: 87
One interesting thing is the car went on a relatively steep uphill before this happened - and from the sounds of things water could have traveled rearwards on the car and settled on one or other control module... some suggest the transfer case control module? This can short out a few things.
There was one comment by an aussie on another forum who had his car in deep water and had almost the exact same error faults appear after driving uphill soon after being in deep water ... he ended up needing an engine rebuild.
The coolant is also poor at evaporating so may take some time before we get a good sense of what the story is. Maybe Ill park a heater under the engine for a bit - coolant rather poor at evaporating.
I'll try resetting all codes and see how I get on.
30th Jan 2022 12:10 pm
stevebez
Member Since: 18 Apr 2011
Location: Kent
Posts: 87
Codes on main page don't clear .... Guess will have to call RCV or dealer. Ouch.
30th Jan 2022 3:20 pm
stevebez
Member Since: 18 Apr 2011
Location: Kent
Posts: 87
So .. Jardine says motor is gone.
Said motor does not turn over and metal in oil pan etc... need new motor and Turbo's.
Odd as I managed to turn it over by hand and temps never went high either.
Interesting they say I need a new motor and not even considering having the existing one rebuilt.
LR4 with 80k miles.
Any bright ideas here? Clearly not plugging in a brand new engine
4th Feb 2022 9:16 am
popsdosh
Member Since: 09 Nov 2009
Location: cambs
Posts: 442
im afraid I was suspecting such . Jardine im sure are just using the terminology of new engine as JLR only fit remanufactured short blocks when the crank goes ,it will be likely to be around £13.5k if they are doing it and possibly more if not billing it to JLR, have heard up to 17k with turbos . Sorry to say at that age you will need to consider if its worth the cost even a good independent and you need a good one wont leave much left out of £10k for that job.
For what its worth temps wont have gone up as that is typical of a broken crank.
5th Feb 2022 8:32 am
M3DPO
Member Since: 22 Sep 2010
Location: Notts.
Posts: 8226
You’ve got my sympathy, after reading these incidents it really makes me wonder if it’s time for a change It can when others can't,
It will when others won't,
It goes where others don't.
5th Feb 2022 8:48 am
robpenrose
Member Since: 12 Jan 2016
Location: Surrey / SW London
Posts: 2138
Sorry to hear of your bad luck.
Maybe have a chat with Oval Autos and QP Online
Current: D4 HSE
Previous: BMW Z4M Coupe
Previous: Land Rover Defender 90 CSW Td5
Previous: Land Rover Discovery Td5 ES
5th Feb 2022 9:23 am
stevebez
Member Since: 18 Apr 2011
Location: Kent
Posts: 87
Engine pulled apart and we have ?
Two melted pistons.
On firewall side of the motor.
Any thoughts on what is salvageable / repairable?
Err how do I get the photos to upload?
Last edited by stevebez on 18th Apr 2022 12:54 pm. Edited 1 time in total
18th Mar 2022 9:07 am
OvalAutos
Member Since: 28 Dec 2018
Location: Cradley Heath
Posts: 382
Melted pistons can be caused by either faulty fuel injectors (whoever does the work, make sure the injectors are properly tested) or the piston cooling spray jets are blocked. Have also seen this from being mis- fuelled.Joe
18th Mar 2022 11:18 am
stevebez
Member Since: 18 Apr 2011
Location: Kent
Posts: 87
I think I botched the coolant res re-re - did not bleed coolant adequality is my guess..... Pistons overheated and ... on same end of the engine seems coincidence for fuelling - more likely a trapped air methinks
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
... All LED interiors lights, DRLs, Spare Wheel protector.
