Member Since: 20 Sep 2010
Location: pembrokeshire, wales
Posts: 95
Restricted performance - filter or sensor
Hi all,
I am getting “restricted performance” up on my 2010 D4 on a fairly regular basis. I’ve plugged the nanocom in and have got the following message back which I’m guessing is the cause....
Does this refer to water in the fuel or is it the sensor itself. I seem to remember reading somewhere that the sensor can be troublesome. Although I’m getting “restricted performance” and a yellow warning triangle it drives no different to normal
Dave
17th May 2019 2:01 pm
Dazz360
Member Since: 03 Sep 2016
Location: West Mids Walsall
Posts: 873
For cost wise I’d change filter for Delphi and clean all sensors MAP/MAFMetal auto sump & fluid change (3 hrs)
LR door puddle projectors (10 mins)
Tinted Bonnet wind deflector (10 mins)
All Intercooler pipes and Tbolts (2hrs)
3 injectors replaced so far (30mins)
Sunroof drain pipes both sides 2.5 hrs)
Rear discs, shoes,pads,callipers,flexi hoses, rigid brake line, n/s upper hub carrier bush and rear n/s upper arm (13hrs over 2 days)
17th May 2019 6:12 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20844
3.0 models require a new filter housing. Very common issue
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
