Member Since: 12 Dec 2005
Location: The Gaff
Posts: 50978
Well I've had 5 of their finest and not had a shut line issue ...maybe I'm lucky
Then again ...when you look back at the thousands of threads on this site I can only find a half a page of search results where "shutlines" or "shut lines" are presented as an issue. It's obviously another non issue for the vast majority 21 year LR veteran > D2 GS 2003 > D3 S 2006 > D3 HSE 2009 > D4 HSE 2013 > D4 HSE 2015 > D5 HSE 2018 > DS HSE R-Dynamic P300e 2021
5th Mar 2016 5:25 pm
Gareth Site Moderator
Member Since: 07 Dec 2004
Location: Bramhall
Posts: 26772
Willbrad wrote:
I've heard form someone in the JLR design department that shut lines are a problem for them and they can't get the same quality and consistancy as their German competitors......
Yes but they have stopped making the Defender now.
5th Mar 2016 5:32 pm
J77
Member Since: 03 Mar 2008
Location: Fife
Posts: 6270
My DS drivers door was slightly out and the tailgate on this one has to be slammed to shut it, it's been tweaked by dealer and seems a bit better but my other 6 LRs have been fine.
It doesn't put me off but it's something I would like to see improve.
We all agree, the world is all good, let's hold hands and sing 23.5MY Defender 90 X-Dynamic SE D250 MHEV Pangea Green
5th Mar 2016 5:36 pm
MHP
Member Since: 31 Dec 2011
Location: lydd
Posts: 2776
Willbrad wrote:
I've heard form someone in the JLR design department that shut lines are a problem for them and they can't get the same quality and consistancy as their German competitors......
maybe they're using the same technique as they did on the defender
Big hammer and a block of plastic 2009 Discovery 3 HSE - Gone
2019 Anniversary Edition D5 - Going
2019 HSE D5 - coming!
5th Mar 2016 5:40 pm
DG Site Moderator
Member Since: 12 Dec 2005
Location: The Gaff
Posts: 50978
Hey.... I'm always singing ...and always willing to hold hands 21 year LR veteran > D2 GS 2003 > D3 S 2006 > D3 HSE 2009 > D4 HSE 2013 > D4 HSE 2015 > D5 HSE 2018 > DS HSE R-Dynamic P300e 2021
So my understanding is that the door may shut beautifully and 'seat home' just as it should with a satisfying thud/clunk but then you get an uneven gap round the door/tailgate/boot/bonnet. This is the issue JLR have that other manufacturers don't have. It's a manufacturing problem that just shouldn't exist on a vehicle in this category.....
5th Mar 2016 5:55 pm
J77
Member Since: 03 Mar 2008
Location: Fife
Posts: 6270
DG wrote:
Hey.... I'm always singing ...and always willing to hold hands
Hand across the border brother 23.5MY Defender 90 X-Dynamic SE D250 MHEV Pangea Green
5th Mar 2016 6:11 pm
ste m
Member Since: 13 Apr 2015
Location: Liverpool
Posts: 129
JLR are working on getting smaller shut lines across the whole range. Its not an easy task. Why anyone is obsessed with small shut lines ill never know, i just like nice clean lines simple. I don't want it all to be seamless, i just want top quality
5th Mar 2016 10:00 pm
defector
Member Since: 23 Feb 2009
Location: Greater Manchester
Posts: 1471
Aerodynamics - why do you think they tape up seams/shutlines in fuel economy runs.
6th Mar 2016 12:56 am
tayaste
Member Since: 15 May 2013
Location: Chester
Posts: 7633
Is it to stop bits falling off the cars?
6th Mar 2016 5:08 am
crews control
Member Since: 18 Mar 2007
Location: Dorset
Posts: 5011
...and the drivers inside.
6th Mar 2016 9:22 am
ste m
Member Since: 13 Apr 2015
Location: Liverpool
Posts: 129
I think the difference between weight saving and shut lines may be slightly more
6th Mar 2016 8:59 pm
LT
Member Since: 31 Dec 2005
Location: South West
Posts: 23822
I'm not overly bothered about neat shut lines, as long as the doors open and close properly and don't leak etc.
I had the exact same issue with the tailgate on my last two D4's (MY14 & MY15). As I said earlier, some people might just think that you have to really slam the tailgate to shut it and never realise that's not the case. It's only because the tailgates on MY06 and MY10 D3 & D4 were aligned properly, that I knew this wasn't the case. I don't think, I posted about it at the time, at least I can't remember doing so. I didn't think it was worth mentioning.
I also noticed it on one of the two MY15 HSE's that I was lent recently, when the front discs and then finally the hubs were being replaced on my D4. So it's clearly a common issue, albeit one that maybe doesn't get reported always. Unless, of course I had the only three D4's with this issue. 2006 D3 HSE (Original & still the best)-GONE
2010 D4 HSE (A bit bling)-GONE
2014 D4 HSE (Almost too bling)-GONE
2015 D4 HSE (A heated what?)-GONE
2016 D4 Landmark (Written Off)-GONE
2016 D4 Landmark (Surely the last!) PD1881 rims-GONE
2017 FFRR SDV8 Autobiography (now semi-retired)
Aerodynamics - why do you think they tape up seams/shutlines in fuel economy runs.
See Derek, we were trying to help your fuel economy when we taped you into your car
7th Mar 2016 4:34 pm
Stuff
Member Since: 04 Sep 2015
Location: In between cradle and grave
Posts: 510
RDR wrote:
Long drive today and sat behind various RRS2's and started to notice the cr@p alignment of the tailgate. If you follow the line above the number plate and look where it meets the corresponding line above the tail lights the left and right sides were very noticeably different on them all to the point I would have been asking the dealer to fix them. One was a good 1cm lower on one side.
I have this on my RRS2 and I have looked at it closely. It's not the tailgate. The number plate frame slips on one side. Visually, it's awful. I've seen it on other makes of car. The frame needs to be fixed properly.
Now, the two front doors and the rear tailgate on our new D4 were grossly misaligned when it was delivered. The tailgate still isn't quite right - I'll have to take it back to the dealer again or post a "how to" question on here and try a DIY fix.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
