Mali
Member Since: 25 Nov 2021
Location: Pembrokeshire
Posts: 1
  
|
Hi. Having a bit of nightmare with the D3. The compressor (AMK) went a couple of months ago, replaced that and all went well for a little while. Lately it is coming up with loads of faults, no special programs available, HDC fault, suspension fault do not exceed 30mph… all sorts really.
A quick plug in (icarsoft LR) says…
C1A36-01 permanent exhaust valve.
C1A00-88 permanent control module.
It is currently stuck with the back end very high and the front end sort of normal height.
About 5 seconds after start up it says suspension fault, at no point does the compressor start.
The only thing I can see that’s iffy is the battery is showing 11.9v and despite the clamp being tight on the negative terminal, it’s isn’t a really great connection.
Any suggestions would be greatly appreciated.
Cheers,
Mart.
|
 27th Nov 2021 5:14 pm |
|
|
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10360
 
|
1. Fix the battey connection / low voltage
2. Could be a wiring issue to the exhaust valve (which is part of the compressor)
|
| 27th Nov 2021 5:31 pm |
|
|
