As well as participating on the site Nick very kindly offers 20% off all LR accessories to site members, see this thread. Don't forget to donate some of your savings to the site The End
17th Jun 2007 9:51 pm
Wex
Member Since: 16 Apr 2007
Location: Knackeragua
Posts: 5173
Barrry ,
Let us know how you get on as I was thinking of doing the same , lamps , spots & A-bar .
Thanks , D
18th Jun 2007 8:32 am
BarryG
Member Since: 30 Apr 2006
Location: Eire
Posts: 1333
The new driving light were installed tonight a bit of work in them ok, cutting the dash with
a Stanley knife was great fun.
After I did the install my new Lights will not work ,
Am i correct in saying that I now need to visit my local land rover dealer and have
him enable this option on my Disco's ECU.
19th Jun 2007 12:54 am
sideview
Member Since: 02 Dec 2006
Location: in the valley
Posts: 1663
Seems I've read that you do. Post some pics of the updated Barry Disco when ya can please 8)I'm not so good at giving advice...may I offer you a sarcastic comment instead?
Member Since: 30 Apr 2006
Location: Eire
Posts: 1333
Some Pics for you , (crap camera phone, sorry )
access to fuse panel , removing battery and running new cable to fuse box.
Under fuse box , female plug is already installed by landrover , new wire loom to lamps
plug in here.
new relay installed , and new 15A fuse installed into fuse box.
lamps fitted to A-bar (two bolts each) lamps then plug into new wire loom
Inside cabin now, remove Lights switch and plug out loom from back of switch.
you get a new loom with the lamps that needs to be piggiy backed into this plug
Funny one this , looking at the black plastic plug and its stamped all over with "ford"
logo's ,
location of new switch , mark out area to be cut.
good sharp knife for this
cut out slot , drill 2 x 6mm and insert new mount point
new switch
You need to run a few more wires to the passanger side now (one earth and one piggy back)
All done now.
Next Thing will be the retrofit on the foglamps , the new bezel's are away being colour coded
to Jave , once back I'll be removing the A-bar , then remvoving the bumper and Cutting
two big holes , more pics once done and sorry about the crap quality pics
Yes the ECU needs reprogramming.Loving the power of the TDV8!
19th Jun 2007 1:21 pm
Wex
Member Since: 16 Apr 2007
Location: Knackeragua
Posts: 5173
Brave Man Barry Dont know if Id have the balls on the wiring and Stanley Surgery . Look forward to the updates . As another mod option have you seen this post , just found it today
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum