tintenter
Member Since: 29 Sep 2006
Location: Oldham
Posts: 1112
  
|
| D4 Remote heat receiver possible issue |
|
ok done a search and no wiser
if i already have timed/parking heat available (2015 HSE) and i fit the reciever and arial do i need to still activate anything in the CCF for it to work,
plip/phob seems to be talking to reciever but not getting anything from FBH or flashing light on dash as i do with timed activation
when i press on i get green led then a flash every so often until i press off then i get red led
open to suggestions  Tintenter
Corris Grey Discovery 4 HSE
Bigger permagrin now installed
Semper in excretum, sole profundum moveat.
|
 1st Feb 2016 4:56 pm |
|
|
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14372
|
Yes it needs enabling G4 Gone ...but not forgotten
|
| 1st Feb 2016 5:07 pm |
|
|
tintenter
Member Since: 29 Sep 2006
Location: Oldham
Posts: 1112
|
Adrian thanks for the quick response Tintenter
Corris Grey Discovery 4 HSE
Bigger permagrin now installed
Semper in excretum, sole profundum moveat.
|
| 1st Feb 2016 5:13 pm |
|
|
tintenter
Member Since: 29 Sep 2006
Location: Oldham
Posts: 1112
|
will have to get the MSV2 sorted now then as not connected it since getting new license sorted  Tintenter
Corris Grey Discovery 4 HSE
Bigger permagrin now installed
Semper in excretum, sole profundum moveat.
|
| 1st Feb 2016 5:15 pm |
|
|
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
|
| Re: D4 Remote heat receiver possible issue |
|
tintenter wrote:if i already have timed/parking heat available (2015 HSE) and i fit the reciever and arial do i need to still activate anything in the CCF for it to work,
I removed the time heat control from my 2010 HSE and fitted it to the new 2016 HSE Lux as the dealer had programmed the CCF before delivery foc.
However it turned out that although the fly lead is the same moulded plug on both cars, the 2010 receiver was not compatatble with the 2016MY so the fbh could not be fired up from the remote. 
|
| 1st Feb 2016 5:30 pm |
|
|
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14372
|
Are you sure the dealer did enable it ?
I'd be very supprised if they did !!
Iv not had any issues fitting the same part number to 2016MY ( as earlier ones ) G4 Gone ...but not forgotten
|
| 1st Feb 2016 6:26 pm |
|
|
|
|
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
|
They enabled it along with tow electrics prior to handing the car over.
I fitted the fbh receiver but it didn't activate. They had the car back for a few days for other faults and tried to get the receiver to work then decided the part number had changed between 2010 and 2016 models.
I must swop receivers and see what happens!
|
| 1st Feb 2016 6:38 pm |
|
|
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14372
|
I think there telling you porkies 
I betting it's not been activated G4 Gone ...but not forgotten
|
| 1st Feb 2016 6:43 pm |
|
|
Russell
Member Since: 23 Aug 2007
Location: Kent
Posts: 10564
|
Disco_Mikey wrote:Dealer tool is incapable of retro-fit/enable of timed climate, or RPH
Oh yes they can, my dealer activated it on my D4 previously with no issues what so ever MY17 D5 1st Edition Namib Orange
MY15 D4 HSE Kaikoura Stone
MY12 D4 HSE Nara Bronze Sold and gone
MY11 D4 HSE Stornaway Grey Sold and gone
D3 S spec Silver Sold and gone
Tow bar, full length roof bars, side steps, tow bar storage unit, surround camers.
D4 camera club
|
| 1st Feb 2016 7:10 pm |
|
|
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
|
wiggs wrote:I think there telling you porkies
I betting it's not been activated
Porkies
Work not carried out
The order forms certainly had it on to activate - tow electrics work as they should with rear park sensor and approaching vehicle warning in mirrors deactivated .
Bearing in mind the new unit has the same socket as the old one its hard to beleive they are not the same.
From what you have said, I will swop them over tomorrow and see what works. Just hope I can reach without removing the panel again.
If it works then there will be some questions to be asked. 
Will up date once done
|
| 1st Feb 2016 7:27 pm |
|
|
Bodsy
Site Sponsor
Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361
 
|
I use the same receiver part for all d4 installs I do, from 2009 D4 right through to 2016.
Tintenter, I haven't looked on BBS site for a while, but is the MSV2 ok for 2015 D4? Thought there was some issue a while back, but I can't confirm as I've not looked. Bodsys Brake Bible
D4/D3 Remote FBH heat kits
BAS Remaps/ EGR Blank
Transmission Flush
Software updates/enabling
Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset
See It Here
|
| 1st Feb 2016 8:23 pm |
|
|
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14372
|
Russell wrote:Disco_Mikey wrote:Dealer tool is incapable of retro-fit/enable of timed climate, or RPH
Oh yes they can, my dealer activated it on my D4 previously with no issues what so ever
Dealers were given access to enable timed climate from about 2012 if my memory serves me correctly G4 Gone ...but not forgotten
|
| 1st Feb 2016 8:29 pm |
|
|
|
|
BBDisco3
Member Since: 23 Nov 2008
Location: Cheshire
Posts: 3646
|
The receiver was removed about 4 weeks before being refitted to the new car.
During the period of having no power connected could it loose communication with the remote key fob?
|
| 1st Feb 2016 8:31 pm |
|
|
