stubert
Member Since: 09 May 2016
Location: midlands
Posts: 7
|
HI All
New to the forum so learning alot from here.
The airbag light has come on and l want to check wires and connections under the seats, Read the forum you say make sure the vehicle is asleep does this mean leave it with key out or to disconnect the battery ?
Any advice on the matter please.
thanks
Stu
|
12th May 2016 5:37 pm |
|
|
geoffsnook
Member Since: 13 Jun 2014
Location: south wales
Posts: 3169
|
Turn it off with the window open so keys don't get locked in and wait for the handbrake light to go out then its asleep usually 10-25 mins then you can pull bonnet catch through open window (another reason for leaving window open) and pull bonnet and disconnect battery and release air bag or what you need to do:thumbsup: Discovery 3 se gone
Range rover sport supercharged here:)
|
12th May 2016 5:57 pm |
|
|
stubert
Member Since: 09 May 2016
Location: midlands
Posts: 7
|
Thanks for that not removing airbag just checking wires under seats and connections first lol
|
12th May 2016 6:02 pm |
|
|
grzesiul
Member Since: 11 May 2008
Location: UK
Posts: 6326
|
takes 2 min roughly for system to hibernate
i your seat moves a lot it is usual reason for plug going crazy
wait for handbrake light go off
unscrew clean and reconnec firmly
if still there need to troubleshhot other areas of SRS
G
|
12th May 2016 6:06 pm |
|
|
stubert
Member Since: 09 May 2016
Location: midlands
Posts: 7
|
Thanks for your help Guys.
If i disconnect the battery do i need a code for the radio as looking through paper work l don't seem to have one.
|
13th May 2016 11:58 am |
|
|
geoffsnook
Member Since: 13 Jun 2014
Location: south wales
Posts: 3169
|
I have never needed a code Discovery 3 se gone
Range rover sport supercharged here:)
|
13th May 2016 12:15 pm |
|
|
WillyEckerslike
Member Since: 22 Aug 2013
Location: Out in the world
Posts: 967
|
D3 radios don't need a code.
|
13th May 2016 12:29 pm |
|
|
stubert
Member Since: 09 May 2016
Location: midlands
Posts: 7
|
ok guy's thanks here goes lol
|
13th May 2016 12:31 pm |
|
|
stubert
Member Since: 09 May 2016
Location: midlands
Posts: 7
|
Well done it no change but while l had the wiring out from under seat l found that one of the wires before the multi plug had been trapped and the insulation had been rubbed off and you could see the copper wire.
Is their any fuses that it might have blow cause after taping it and reseting it still light on.l think the wire goes to the pretensioner.
Thanks
Stu
|
13th May 2016 2:38 pm |
|
|