Member Since: 02 Oct 2017
Location: lincoln
Posts: 81
C1A53 epb
I know it's been done to death but I'm having trouble picking through the sheer volume of it all
I bought the D3 a week ago now, it had a known suspension fault and the discs all needed replacing. Between getting it home and changing the discs, pads and shoes, the battery died and epb fault appeared (flashing red and constant amber on dash) it worked to my advantage in a way because I didn't need to put it in service mode to do the rear brakes.
All done ok (I'm a qualified mechanic, out of the trade now and epb weren't about when I was), all adjusted as per bodsy's bible and then did the replacement compressor. In the mean time, I charged the battery for 24hrs and cleared the fault codes.
The epb problem has stayed with C1A53 - sadly my delphi reader doesn't give the following two digits. The module sounds like it winds back and forth several times before giving up but that's as much as I've looked into it so far. I cleared the fault code but it came back on when I pulled the switch but I haven't tried bedding the shoes in yet and the car hasn't moved an inch.
Any suggestions where to start looking?
1st Feb 2018 9:58 pm
Admirable
Member Since: 19 Jul 2015
Location: Fife
Posts: 1034
C1A53 = Electronic parking brake latching failure, emergency release has been activated
1st Feb 2018 10:08 pm
hotshot
Member Since: 02 Oct 2017
Location: lincoln
Posts: 81
Thankyou - I haven't though
1st Feb 2018 10:11 pm
hotshot
Member Since: 02 Oct 2017
Location: lincoln
Posts: 81
Seems to me it's not latching - there's no screech and it's not jamming on, does that help at all?
1st Feb 2018 10:44 pm
hotshot
Member Since: 02 Oct 2017
Location: lincoln
Posts: 81
still no further on with this - I've re-adjusted both sides this afternoon
It occurred to me that one cable might have snapped? I've just stopped for a breather but think the n/s might have come on but not the offside. I think once I've eaten I'll take the offside drum back off and try pulling the end - if the cable pulls through then obviously it needs a cable
does that sound feasible?
2nd Feb 2018 6:31 pm
hotshot
Member Since: 02 Oct 2017
Location: lincoln
Posts: 81
gave up for today, I couldn't bring myself to go back to it. I have made a minor breakthrough though, fingers crossed.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum