Member Since: 27 May 2018
Location: North Wales
Posts: 3
EGR Blanking???
I've been happily motoring along in my remapped disco 3 until I decided to fit an EGR blanking kit. After fitting there is little power up to 2000 revs then plenty after that. I seem to have have created the symptoms that people fit the EGR blanking kit in the first place. What could I have done while fitting the kit that could have caused the lack of power?
28th May 2018 10:59 am
gstuart
Member Since: 21 Oct 2016
Location: kent
Posts: 13672
hi
did u remove the butterfly assembly inside the throttle body and clean out ur MAP sensor
also are u aware of the new mot rules concerning EGR blanking
Last edited by gstuart on 28th May 2018 11:08 am. Edited 1 time in total
28th May 2018 11:07 am
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 4683
Check all the electrical connections, if that doesn't help have your diagnostic codes read and go from there.
28th May 2018 11:08 am
Jhoopert
Member Since: 27 May 2018
Location: North Wales
Posts: 3
Butterfly removed as per fitting instructions. I shall clean the map sensor and check the electronic connections.
28th May 2018 11:30 am
KAIBO
Member Since: 16 Apr 2018
Location: Staffordshire
Posts: 18
It's easier to get the egr removed in the software no messing about with blanking plates removing parts looks standard. Removes all these issues.Some people live in the fast lane I seem to live in oncoming traffic.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum