john watson
Member Since: 10 Nov 2011
Location: lanark
Posts: 957
|
Rear drive shaft stake nut |
|
The Haynes manual give a torque value of 350NM . In light of the torque value for the front drive shaft stake nut values being reduced has the rear been reduced also? Once you have defeated the idiots any job is half done. Pity there are so many idiots to defeat.
|
23rd Jul 2018 11:09 am |
|
|
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 4658
|
I did rear wheel bearings a few months ago and torqued 350 nm as I was not aware of any change. Done about 6k miles since and wheels are still on
|
27th Jul 2018 1:38 am |
|
|
john watson
Member Since: 10 Nov 2011
Location: lanark
Posts: 957
|
Thanks for that.
Will need to look out the piece of scaffolding pipe yet again Once you have defeated the idiots any job is half done. Pity there are so many idiots to defeat.
|
27th Jul 2018 8:09 am |
|
|
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 4658
|
Will that be a 350 metre long pipe?
|
27th Jul 2018 1:26 pm |
|
|
john watson
Member Since: 10 Nov 2011
Location: lanark
Posts: 957
|
Is that how you would do it in Ireland? Once you have defeated the idiots any job is half done. Pity there are so many idiots to defeat.
|
27th Jul 2018 2:24 pm |
|
|
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 4658
|
Depends on how much of the "black stuff" has been consumed
|
27th Jul 2018 2:45 pm |
|
|
john watson
Member Since: 10 Nov 2011
Location: lanark
Posts: 957
|
Well in the words of the old song “ are you right Michael are you right if not we could be here all night
You know the other day they dug up the permanent way, are you right Michael are you right “ Once you have defeated the idiots any job is half done. Pity there are so many idiots to defeat.
|
27th Jul 2018 3:12 pm |
|
|
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 4658
|
I'm starting to think you might have been at the black stuff yourself
|
27th Jul 2018 3:26 pm |
|
|