Member Since: 12 Oct 2012
Location: hemel hempstead
Posts: 72
GAP IID MOUNTING POSITION
Can you use the GAP IID BT to put the discovery 3 when working on the handbrake shoes into a mounTing position to make it easier to get the rear shoes on and off, JEFF=BONES1.
17th Mar 2019 3:45 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10689
YeA you can
17th Mar 2019 3:57 pm
bones1
Member Since: 12 Oct 2012
Location: hemel hempstead
Posts: 72
thanks, but where do you go,what section and what do you click on. on the gap iid bt tool.when you have done the brakes how do you get it out of the mounting position? jeff=bones1.
17th Mar 2019 4:58 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10689
what is a gap2 ?
We have gap IID BT here
Any I don't know, did it the hard way
17th Mar 2019 5:25 pm
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 5052
Re: GAP 2D MOUNTING POSITION
bones1 wrote:
Can you use the GAP2D BT to put the discovery 3 when working on the handbrake shoes into a mounTing position to make it easier to get the rear shoes on and off, JEFF=BONES1.
Just follow this from Bodsy to the letter, and you'll have no problems!
Member Since: 15 Jan 2014
Location: The Cotswolds
Posts: 1391
And if you still want to do it, it's covered in the IID manual. Worth a read.2016 Skoda Octavia VRS Estate
<gone>2009 FF Vogue TDV8 Buckingham Blue</gone>
<gone>2015 BMW 520D SE (not my favourite car)</gone>
<gone>2009 D3 HSE Galway Green</gone
17th Mar 2019 11:13 pm
Gareth Site Moderator
Member Since: 07 Dec 2004
Location: Bramhall
Posts: 26776
Can I just ask the regular iid users a bit about this process. I am currently replacing my rear discs and the epb needs a good clean and lubrication. I have the iid, and have read the manual.
Page 150 does indeed tel me that the tool can set the epb to Mounting position, or Relatch. It does not give much information on exactly what to do, other than the fact that the ignition should be on, with the engine off, and the epb not applied.
There are simply 2 buttons on my phone screen, Relatch or Mounting. When I select Mounting, there is no confirmation or noise or anything to confirm that it has actually done anything. Is this right?
23rd Feb 2020 7:21 pm
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 5052
Gareth I believe the IID mounting position is the same as manually selecting the "service mode" as per bodsy's bible.
Although I always use "service mode" I have never noticed any obvious actuation when this is selected. However, my understanding is it relieves any tension on the cables to assist with the disassembly and refitting of the disc's and shoes.
If my interpretation is incorrect I have no doubt clarification will be incoming and imminent yµ (idµ - eAµ) ψ=mψ
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
