Member Since: 26 Oct 2013
Location: Liverpool
Posts: 697
Lighting strikes twice? Another dead D4
I’ve not been on here for ages. All was well in Land Rover ownership land. Until it wasn’t…
Earlier today got a call from my wife that the D4 had died. No warning, errors or anything. Just a sudden loss of power and funny noise. Sounds suspiciously familiar…
I’m currently sat waiting for RAC flatbed recovery. Theory is a belt has let go. The car turns over smoothly but won’t start. Error codes for cam sensor.
The sceptic (realist) in me strongly suspects we have lost another crank and therefore engine. This happened with our old D3 some years ago. Back then, through some major fortune, JLR footed the bill for a complete new engine. Not so sure it will be as happy an outcome this time.
Waiting to get it recovered to Rugged4x4 in Liverpool (I can almost see their workshop from where it’s broken down!) with a hope they can look at it sometime soon.
I ducking hate Land Rovers.Cheers,
Gareth
'57 D3 2.7 TDV6 HSE gone and soon to be forgotten!
‘15 D4 3.0 SDV6 HSE Luxury
'64 Audi A6 3.0BiTDi Quattro S-Line Black Edition with lots of toys
Last edited by wizbongre on 22nd Sep 2024 1:01 pm. Edited 1 time in total
22nd Sep 2024 12:51 pm
wizbongre
Member Since: 26 Oct 2013
Location: Liverpool
Posts: 697
These are the fault codes.
Click image to enlarge
Cheers,
Gareth
'57 D3 2.7 TDV6 HSE gone and soon to be forgotten!
‘15 D4 3.0 SDV6 HSE Luxury
'64 Audi A6 3.0BiTDi Quattro S-Line Black Edition with lots of toys
22nd Sep 2024 12:57 pm
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 5062
If the cam sensor fails (in theory) it shouldn't prevent the engine to continue running during it's cycle, as the PCM uses CKP signals to compensate. However, the cam sensor has failed the engine cannot be restarted until the sensor issue is rectified. So unfortunately I would have to conclude that there is an issue with the timing belt or cam pulley.
The only way to know for certain is the T/belt cover has to come off.yµ (idµ - eAµ) ψ=mψ
22nd Sep 2024 2:53 pm
wizbongre
Member Since: 26 Oct 2013
Location: Liverpool
Posts: 697
Thanks. Assuming it is a belt (and not another crank) what are the chances it’s damaged the top end too?Cheers,
Gareth
'57 D3 2.7 TDV6 HSE gone and soon to be forgotten!
‘15 D4 3.0 SDV6 HSE Luxury
'64 Audi A6 3.0BiTDi Quattro S-Line Black Edition with lots of toys
22nd Sep 2024 3:22 pm
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 5062
If the belt has gone there will be top end damage to the lifters/valves and or cam caps but it's not catastrophic by any means, a bit of work though to get it sorted.
Doubt very much it's the crank or you'd have other codes to support that diagnosis, so fingers crossed.yµ (idµ - eAµ) ψ=mψ
22nd Sep 2024 3:27 pm
wizbongre
Member Since: 26 Oct 2013
Location: Liverpool
Posts: 697
Thanks. Let’s see what happens in the coming days…I’m holding on to the hope that I surely can’t be so unlucky to lose 2 engines to crank problems!Cheers,
Gareth
'57 D3 2.7 TDV6 HSE gone and soon to be forgotten!
‘15 D4 3.0 SDV6 HSE Luxury
'64 Audi A6 3.0BiTDi Quattro S-Line Black Edition with lots of toys
22nd Sep 2024 3:32 pm
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 5062
It's not common for the T/belt to fail unless it's maintenance has been ignored, although I have seen one break after 9,000kms.
It may be something much less sinister so don't loose any sleep over it until you have the covers off. yµ (idµ - eAµ) ψ=mψ
22nd Sep 2024 3:37 pm
itsaguything
Member Since: 20 Dec 2023
Location: Manotick, On
Posts: 262
Agreed. Hypothesizing the worst merely entices worry.. A proper analysis need be completed.2015 LR4 HSE Lux Aintree Green
2013 LR2 HSE Radiance Red
2007 XKR Jaguar Racing Green
2005 XJR Jaguar Racing Green
2002 S-Type R British Racing Green
24th Sep 2024 1:33 pm
wizbongre
Member Since: 26 Oct 2013
Location: Liverpool
Posts: 697
Finally got our car back again and wanted to update on the cause of this...
Turns out both timing chains had snapped, the drive belt had also snapped, and one of the camshaft pulleys had sheered in half. No idea which was the root cause. Ended up having both top ends rebuilt with new rockers and tappets and associated.
Running like a peach now to be fair!Cheers,
Gareth
'57 D3 2.7 TDV6 HSE gone and soon to be forgotten!
‘15 D4 3.0 SDV6 HSE Luxury
'64 Audi A6 3.0BiTDi Quattro S-Line Black Edition with lots of toys
Haven't we had a few on here showing pics of failed pulleys? Suspect that as primary failure ?.
Dean
====================================
2011 D4 XS - OBD port protection, RLD spare wheel protector, All LED interiors lights, Timed Climate enabled, iiD tool paired.
2011 D4 Landmark - Stolen from same dealer before I paid for it
2011 D4 GS - Stolen whilst at dealer ... All LED interiors lights, DRLs, Spare Wheel protector.
1996 300Tdi - Eaten by tin worms
4th Dec 2024 1:33 pm
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 5062
wizbongre wrote:
Finally got our car back again and wanted to update on the cause of this...
Turns out both timing chains had snapped, the drive belt had also snapped, and one of the camshaft pulleys had sheered in half. No idea which was the root cause. Ended up having both top ends rebuilt with new rockers and tappets and associated.
Running like a peach now to be fair!
Most people seem to spend their time worrying about crank failure when the focus of their concerns really should be on the cam pulleys and timing chains especially after 150k miles.
Glad you have it sorted now and if you look after it you should see many years of trouble free motoring, yµ (idµ - eAµ) ψ=mψ
4th Dec 2024 11:28 pm
wizbongre
Member Since: 26 Oct 2013
Location: Liverpool
Posts: 697
Only done 75k miles!
Had to have 2 turbos replaced 12months ago too.
Last LR we will ever buy for a long time. Really wanted to go for a D5 at some point but lost all confidence now.Cheers,
Gareth
'57 D3 2.7 TDV6 HSE gone and soon to be forgotten!
‘15 D4 3.0 SDV6 HSE Luxury
'64 Audi A6 3.0BiTDi Quattro S-Line Black Edition with lots of toys
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum