Member Since: 23 Nov 2017
Location: Stevenage
Posts: 990
Sticking tsov
How do I check if the turbo shut off valve (tsov valve )is ok I can move by hand slightly but it quite hard to move
I have disconnected the vac pipe and attached another to it and sucked on it and it hardly moves really is it suppose to be hard or move very easily i
Just trying to track down a restricted performanceDisco 3 gone but not forGotten
Welcome disco 4
Flappy paddles working from gap
Heated steering wheel done
Bluetooth iPod connection done
Xeon lights (facelift) done
Afs retrofit done
Logic 7 retrofit done
Armrest fridge
Facelift rear lights
Retrofit High beam assist done
Genuine 22” Range Rover sport alloys
Retrofit acc (gave up not possible)
retrofit tpms done
Retrofit Range Rover lcd digital dash. Done
Retrofit blind spot assist done
26th May 2020 9:20 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20733
they are quite tight to move. Best way to check is with a vacuum tester My D3 Build Thread
Member Since: 23 Nov 2017
Location: Stevenage
Posts: 990
It did move if I suck the life out of the pipe just didn’t know if that’s how hard it should be
Just keep getting p2263 comming up found a
Few broken vacuum lines replaced thoseDisco 3 gone but not forGotten
Welcome disco 4
Flappy paddles working from gap
Heated steering wheel done
Bluetooth iPod connection done
Xeon lights (facelift) done
Afs retrofit done
Logic 7 retrofit done
Armrest fridge
Facelift rear lights
Retrofit High beam assist done
Genuine 22” Range Rover sport alloys
Retrofit acc (gave up not possible)
retrofit tpms done
Retrofit Range Rover lcd digital dash. Done
Retrofit blind spot assist done
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum