omg!
Member Since: 01 Jun 2011
Location: Fife
Posts: 569
|
I have logged the following codes:
Suspension
C1A07-62 (2E) Cross articulation - Algorithm based failure - signal compare failure
( at 221011 mi )
Vehicle Dynamic
U0132-87 (08) Lost communication with ride level control module - Bus signal/message failure - missing a message
( at 221011 mi )
I have searched and found that it could be either a calibration issue, a height sensor issue or wiring.
When I went to the car the OSR was on the stops and much lower than the other 3 corners. Would this indicate a height sensor on that corner?
TIA
|
14th Nov 2021 8:11 pm |
|
|
|
omg!
Member Since: 01 Jun 2011
Location: Fife
Posts: 569
|
Thank you.
I found your thread earlier and I was going to use it as a guide tomorrow.
I noticed though that you had a sensor fault come up and I didn't get that fault.
I only the two faults below and I recon the important one is the C fault as the U fault was probably caused by the failure reported in the C fault.
I was hoping that the lower OSR corner might be a clue that someone might recognise and be able to say that the problem lies there.
|
14th Nov 2021 8:24 pm |
|
|