Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > In Car Electronics (D4)

roof antenna
Post Reply  Down to end
Page 1 of 1
thomasz
 


Member Since: 01 Oct 2021
Location: Kulmbach
Posts: 108

Germany 2010 Discovery 4 TDV6 SE Manual Nara BronzeDiscovery 4
roof antenna

Hi,

my D4 currently has no antenna on the roof (just a plastic cover). I would now like to mount a combination antenna (DAB+ and GPS) here. Did anyone else do this before? How do I access the bottom so I can remove the plastic cover?

Does a shark antenna fit or does it not cover everything on the roof?

Thomas
  
Post #231481413th Nov 2022 6:24 am
View user's profile Send private message View poster's gallery Reply with quote
Trailered Movements
 


Member Since: 16 Jan 2020
Location: East/West Sussex Coast Borders
Posts: 1200

United Kingdom 2011 Discovery 4 3.0 SDV6 Commercial Auto Sumatra BlackDiscovery 4

I fitted a shark fin for DAB reception.

Thought it would be a simple matter of removing the plastic blank already on the roof, but this appeared to be bonded in place.

Ended up fitting the new aerial immediately behind the plastic blank, there was just enough room, but it did involve butchering the metal inner roof panel strengthening.

I didn't want to take down the headlining, so worked with it just released from it's fixings at the rearmost edge.

Unfortunately I have sold the car, so can't get you any pictures.

I did buy a decent, as in not cheap chinese aerial, as took the view I didn't want to have to revisit the area again.


Dave
 2011 Discovery 4 Commercial SDV6 (Gone)
2010 RRS TDV8 (Gone)
1980 OBLIC 4.0ltr Range Rover (went a long time ago) 
 
Post #231482913th Nov 2022 11:33 am
View user's profile Send private message View poster's gallery Reply with quote
Flatlander
 


Member Since: 20 Jul 2015
Location: Here
Posts: 575

United Kingdom 

Drop the 'C' & 'D' pillar trims to allow the headlining to be lowered (but support it so it doesn't crease), as mentioned the plastic is bonded to the roof, don't use gasket remover as it will remove paint as well... Use a single-sided razor blade with lots of masking tape around the blanking panel and cut the thin foam adhesive to release the panel. I used a LR roof housing to mount the GPS & DAB antennas in, a bit tight but worked well - you don't need the LR GPS antenna, any 5V phantom powered (i.e. single coaxial connection) one will work, I used an old Garmin external antenna. Make sure the DAB antenna has a good ground plane and a good connection to the bodywork as close as possible to the antenna.
  
Post #231483313th Nov 2022 1:26 pm
View user's profile Send private message View poster's gallery Reply with quote
thomasz
 


Member Since: 01 Oct 2021
Location: Kulmbach
Posts: 108

Germany 2010 Discovery 4 TDV6 SE Manual Nara BronzeDiscovery 4

Thanks mate!
...that's what I thought.
  
Post #231483913th Nov 2022 2:02 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site