Member Since: 18 Sep 2017
Location: On the NC500
Posts: 541
Help! Height sensor outside of allowed range
Hello All. The suspension on my 2014 D4 has been completely overhauled with new shocks, blocks and height sensors. The garage that has done the work used my IID tool to recalibrate but when trying to recalibrate the osf it always returned an E0 code.
I emailed Gap and they advised this probably means that one sensor is outside the permitted range. When you look at the screenshot it does indeed look like that is the case. The sensors have been switched left to right but the error is still there on the osf.
Any ideas what is causing this out of range reading??
Click image to enlarge
31st Jan 2024 8:13 pm
NC500
Member Since: 18 Sep 2017
Location: On the NC500
Posts: 541
Bump
1st Feb 2024 5:07 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20841
Member Since: 18 Sep 2017
Location: On the NC500
Posts: 541
Thanks Mike but what causes it? Faulty unit? Faulty wiring?
1st Feb 2024 7:17 pm
Huskynose
Member Since: 09 Jan 2021
Location: the Netherlands
Posts: 17
I had a similar problem, a visit to the main dealer sorted this.
Don't know how they fixed it sadly, but I asked them to recalibrate the suspension to factory specs, and they did.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
