Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Technical (D3)

Extreme idle revs after cold start
Post Reply  Down to end
Page 1 of 1
gyroskalamari
 


Member Since: 13 Dec 2021
Location: Munich
Posts: 1

Germany 2005 LR3 4.4 V8 HSE Auto Buckingham BlueLR3
Extreme idle revs after cold start

Hi all,

I have had a (new) problem with my LR3 V8 for a few weeks.

The idle speed has always risen to well over 1000 rpm after starting. For some time now, however, this value has been at 3000 rpm, sometimes even higher. Otherwise, the Disco behaves normally, and the IIDTool cannot detect any errors in the engine control. Hearing the cold engine revving up at this speed gives an unhealthy feeling. When it is warm, the effect no longer occurs.

The friendly guy read out all the relevant sensors without finding anything, updated the ECU, didn't know what to do next and, feeling guilty, wrote me a bill for two hours of work.

The following measures have been carried out so far:

- all errors deleted with the IIDTool, complete reset of the vehicle, PCM engine adaptation values ​​deleted
- air mass meter unmounted, cold start with unplugged air mass meter --> same effect
- cold start with open air filter housing --> same effect
- throttle valve cleaned --> same effect
- cold start with unplugged throttle valve prevents the effect, but leads to an error in the engine control (yellow engine LED on)
- EGR control unplugged --> same effect
- EGR on the intake manifold closed with duct tape --> same effect
- starter battery freshly charged and/or connected to consumer battery via DBS --> same effect
- vacuum hoses towards valve chamber and purge valve (activated carbon storage) disconnected --> speed increases rather than increasing
- accelerator pedal replaced --> same effect
- crankcase regulator valve replaced --> same effect

I looked at the TARGET/ACTUAL values ​​of the throttle valve in the IIDTool “Live Values”. Although they are at different levels on the absolute scale, they behave the same in relative terms.

According to the “Target Idle RPM” value, the engine control unit does indeed command a speed of around 1800 rpm after a cold start, although the actual speed is significantly higher than this.

I'm slowly running out of ideas as to where else to look. Has anyone had a similar experience with the V8 or knows someone who knows someone...

I'm grateful for any advice!

Best regards, Eckard
  
Post #236918920th May 2024 11:01 am
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site