Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Technical (D4)

10 second acceleration delay
Post Reply  Down to end
Page 1 of 1
Khauff
 


Member Since: 05 Apr 2008
Location: Scotland
Posts: 236

United Kingdom 2013 Discovery 4 3.0 SDV6 HSE Lux Auto Fuji WhiteDiscovery 4
10 second acceleration delay

Hi Folks

SDV6 2013 - From cold start up put car in D foot to the floor car just crawls for 10 seconds then builds up speed. Once warmed up it gets a bit better say 5 seconds before picking up speed.

What could be the potential cause?

No warnings on dash will cruise up to 70 etc bit baffled. Never had issue like this before and had car from new only got 60k on clock.

Any help greatly appreciated.

Thanks
  
Post #237828026th Sep 2024 7:35 pm
View user's profile Send private message View poster's gallery Reply with quote
LRD4GAB
 


Member Since: 05 Nov 2020
Location: Tamworth
Posts: 499

United Kingdom 2015 Discovery 4 3.0 SDV6 HSE Lux Auto Corris GreyDiscovery 4

Normal I think mine did that until I had it remapped Smile
  
Post #237830227th Sep 2024 7:24 am
View user's profile Send private message View poster's gallery Reply with quote
Hardware
 


Member Since: 28 Jun 2016
Location: Hiding under the M60
Posts: 13016

United Kingdom 2011 Discovery 4 3.0 SDV6 XS Auto Sumatra BlackDiscovery 4

Check your shoe isn't catching the brake pedal. Only needs the merest of touches and car prioritises braking over acceleration.
 .


Dean
====================================

2011 D4 XS - OBD port protection, RLD spare wheel protector, All LED interiors lights, Timed Climate enabled, iiD tool paired.
2011 D4 Landmark - Stolen from same dealer before I paid for it
2011 D4 GS - Stolen whilst at dealer Sad ... All LED interiors lights, DRLs, Spare Wheel protector.
1996 300Tdi - Eaten by tin worms 
 
Post #237832127th Sep 2024 12:19 pm
View user's profile Send private message View poster's gallery Reply with quote
Weyboat
 


Member Since: 13 Apr 2018
Location: Weymouth
Posts: 273

England 2015 Discovery 4 3.0 SDV6 HSE Auto Corris GreyDiscovery 4

Check the oil level in your gearbox, it could be low on oil causing the torque converter to slip, as the oil warms up it expands and this is why the torque converter performance improves as the oil warms up.
 Gone 2016 Landmark D4
Current 2015 HSE D4 - AKA - 'Gandalf the Grey' 
 
Post #237834627th Sep 2024 7:04 pm
View user's profile Send private message View poster's gallery Reply with quote
Khauff
 


Member Since: 05 Apr 2008
Location: Scotland
Posts: 236

United Kingdom 2013 Discovery 4 3.0 SDV6 HSE Lux Auto Fuji WhiteDiscovery 4

Hardware wrote:
Check your shoe isn't catching the brake pedal. Only needs the merest of touches and car prioritises braking over acceleration.


Checked that and defo not the size 9’s Confused
  
Post #23786682nd Oct 2024 7:58 am
View user's profile Send private message View poster's gallery Reply with quote
Khauff
 


Member Since: 05 Apr 2008
Location: Scotland
Posts: 236

United Kingdom 2013 Discovery 4 3.0 SDV6 HSE Lux Auto Fuji WhiteDiscovery 4

Weyboat wrote:
Check the oil level in your gearbox, it could be low on oil causing the torque converter to slip, as the oil warms up it expands and this is why the torque converter performance improves as the oil warms up.


Very true had transmission serviced from LR dealer 2 years ago and it’s been fine with no leaks. Could get another garage to recheck.
  
Post #23786692nd Oct 2024 8:00 am
View user's profile Send private message View poster's gallery Reply with quote
Khauff
 


Member Since: 05 Apr 2008
Location: Scotland
Posts: 236

United Kingdom 2013 Discovery 4 3.0 SDV6 HSE Lux Auto Fuji WhiteDiscovery 4

In neutral when I push on the accelerator pedal instant rpm rev up.

It drive nothing until 10 seconds so it could be transmission but with the d4 being so technical with sensors nothing flagged up on dash.

Confused
  
Post #23786702nd Oct 2024 8:02 am
View user's profile Send private message View poster's gallery Reply with quote
Weyboat
 


Member Since: 13 Apr 2018
Location: Weymouth
Posts: 273

England 2015 Discovery 4 3.0 SDV6 HSE Auto Corris GreyDiscovery 4

If the problem is less acute when the engine and gearbox has warmed up, then I would be checking the gearbox oil level with the engine running.
There should be a trickle of oil running from the oil level plug, if not add the correct spec transmission oil until it does start to trickle.
The oil should be at a certain temperature when checking, I think it should be between 30 and 50 degrees C.
Make sure the car is parked on level ground when checking the oil level.
See the image for the relevant procedure for checking the oil level, this was taken from 'Robbies Guide to ZF8 Auto Transmission Oil Change'

 Gone 2016 Landmark D4
Current 2015 HSE D4 - AKA - 'Gandalf the Grey' 
 
Post #23786722nd Oct 2024 8:18 am
View user's profile Send private message View poster's gallery Reply with quote
M3DPO
 


Member Since: 22 Sep 2010
Location: Notts.
Posts: 8223

England 2014 Discovery 4 3.0 SDV6 HSE Lux Auto Corris GreyDiscovery 4

Highly likely they didn't do the engine running process when it was changed, surprisingly it takes a fair amount of oil once the engine is started.
 It can when others can't,
It will when others won't,
It goes where others don't. 
 
Post #23787092nd Oct 2024 3:39 pm
View user's profile Send private message View poster's gallery Reply with quote
Khauff
 


Member Since: 05 Apr 2008
Location: Scotland
Posts: 236

United Kingdom 2013 Discovery 4 3.0 SDV6 HSE Lux Auto Fuji WhiteDiscovery 4

Appreciate support and comments.

Restricted performance flagged up on way to garage this morning.



Click image to enlarge




Garage has updated, turbos on way out as too much oil in top intercooler hose. Oil level still showing full when I check digitally, no black/white/blue smoke through the rev range car still pulls like a train apart from 0-20mph

Maf sensor in middle of engine was caked with oil crud which the garage cleaned out.

Carried out smoke test all clear and plastic intakes have no fracture.

Air filter was all clean no trace off oil.


Click image to enlarge


This too much oil folks before I start shelling out on new turbos £££ ? And would this be the cause of the car not willing to build up any speed first start up in the mornings?

Thanks
  
Post #23787943rd Oct 2024 2:07 pm
View user's profile Send private message View poster's gallery Reply with quote
M3DPO
 


Member Since: 22 Sep 2010
Location: Notts.
Posts: 8223

England 2014 Discovery 4 3.0 SDV6 HSE Lux Auto Corris GreyDiscovery 4

I once had this symptom on a Mercedes, it was the inlet manifold!
 It can when others can't,
It will when others won't,
It goes where others don't. 
 
Post #23787993rd Oct 2024 2:59 pm
View user's profile Send private message View poster's gallery Reply with quote
Weyboat
 


Member Since: 13 Apr 2018
Location: Weymouth
Posts: 273

England 2015 Discovery 4 3.0 SDV6 HSE Auto Corris GreyDiscovery 4

Khauff wrote:


Click image to enlarge


This too much oil folks before I start shelling out on new turbos £££ ? And would this be the cause of the car not willing to build up any speed first start up in the mornings?

Thanks


No it is not too much oil, it is normal to find oil in that hose.
The sensor that was cleaned by the garage is the MAP sensor and it measures air pressure in the manifolds, not air flow.

Did the garage check the oil level in the gearbox (with the engine running)?
 Gone 2016 Landmark D4
Current 2015 HSE D4 - AKA - 'Gandalf the Grey' 
 
Post #23788033rd Oct 2024 3:35 pm
View user's profile Send private message View poster's gallery Reply with quote
M3DPO
 


Member Since: 22 Sep 2010
Location: Notts.
Posts: 8223

England 2014 Discovery 4 3.0 SDV6 HSE Lux Auto Corris GreyDiscovery 4

How do you check gb oil level digitally?- it can only be done as described above!- level ground, take filler plug off and fill WITH CORRECT SPECIFICATION OIL AT HAND TEMPERATURE UNTIL IT TRICKLES OUT.
The volume of oil increases tremendously as it gets hot and it gets hot very fast even whilst filling, my thoughts are the oil level is low but in the 0 to 20 mph it increases sufficiently to give you drive.
My inlet hose has oil in it same as in the photo and I don’t have any problems, also as I understand the turbo only becomes active at approximately 1250rpm.
Does the engine rev normally when in park?
 It can when others can't,
It will when others won't,
It goes where others don't. 
 
Post #23788474th Oct 2024 7:44 am
View user's profile Send private message View poster's gallery Reply with quote
Khauff
 


Member Since: 05 Apr 2008
Location: Scotland
Posts: 236

United Kingdom 2013 Discovery 4 3.0 SDV6 HSE Lux Auto Fuji WhiteDiscovery 4

Weyboat wrote:
Khauff wrote:


Click image to enlarge


This too much oil folks before I start shelling out on new turbos £££ ? And would this be the cause of the car not willing to build up any speed first start up in the mornings?

Thanks


No it is not too much oil, it is normal to find oil in that hose.
The sensor that was cleaned by the garage is the MAP sensor and it measures air pressure in the manifolds, not air flow.

Did the garage check the oil level in the gearbox (with the engine running)?


Garage mentioned no fault codes stored with gearbox so they parked that suggestion and focused on the stored restricted performance fault which pinged up on route to garage.
  
Post #23788814th Oct 2024 4:24 pm
View user's profile Send private message View poster's gallery Reply with quote
Khauff
 


Member Since: 05 Apr 2008
Location: Scotland
Posts: 236

United Kingdom 2013 Discovery 4 3.0 SDV6 HSE Lux Auto Fuji WhiteDiscovery 4

M3DPO wrote:
How do you check gb oil level digitally?- it can only be done as described above!- level ground, take filler plug off and fill WITH CORRECT SPECIFICATION OIL AT HAND TEMPERATURE UNTIL IT TRICKLES OUT.
The volume of oil increases tremendously as it gets hot and it gets hot very fast even whilst filling, my thoughts are the oil level is low but in the 0 to 20 mph it increases sufficiently to give you drive.
My inlet hose has oil in it same as in the photo and I don’t have any problems, also as I understand the turbo only becomes active at approximately 1250rpm.
Does the engine rev normally when in park?


Sorry should have been clearer, when garage mentioned turbos sucking too much oil into the top hose for their liking. I decided to check engine oil level as this should have dropped but was still showing full which I was happy to see.

Engine revs perfectly when in neutral and I don’t think it’s the turbos personally. Gearbox oil not filled correctly is also what I am thinking even though it was a LR dealer who carried out the work 2 years ago and only driven car 6,000 odd miles in that two years.

Got it booked into Mikey to work his magic as I know the vehicle will be in safe hands and I can sleep better at night Very Happy
  
Post #23788854th Oct 2024 4:37 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site