Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Technical (D3)

Engine keeps going for 2-3sec after releasing throttle
Post Reply  Down to end
Page 1 of 2 12>
Jacornel
 


Member Since: 12 Dec 2019
Location: Holland
Posts: 13

Netherlands 2008 Discovery 3 TDV6 SE Auto Unknown ColourDiscovery 3
Engine keeps going for 2-3sec after releasing throttle

Hello,

This week i noticed that the throttle respons on my 2008 disco 3 2.7tdv6 is a bit weird. It's best noticed when driving slow (in traffic or just leaving the drive way) When i release the pedal the engine keeps going at around 1500rpm for 2-3seconds. Sometimes it's tricky, because the car wants to keep going forward and you really have to brake 'against' the engine.

Today when driving in traffic (accelerating, stop, accelerating, stop and so on, with constantly this delay in throttle release) the car fell into limp mode twice just showing the message "engine system fault" and even "transmission system fault". No check engine light, just the message and limp mode.

Stop the car, restart it and it was ok again (except for the 'sticky throttle')

Anyone had this problem before?

Could this be an EGR related problem?

Looking forward to your replies.

Regards
Jim
  
Post #210546912th Dec 2019 7:10 pm
View user's profile Send private message View poster's gallery Reply with quote
Globetrotter448
 


Member Since: 21 Mar 2017
Location: Londonderry NSW
Posts: 1818

Australia 2007 Discovery 3 4.0 V6 Petrol SE Auto Java BlackDiscovery 3

More likely throttle body not shutting properly due to gunk.
  
Post #210565513th Dec 2019 9:15 am
View user's profile Send private message View poster's gallery Reply with quote
Dazz360
 


Member Since: 03 Sep 2016
Location: West Mids Walsall
Posts: 873

United Kingdom 2005 Discovery 3 TDV6 HSE Auto Bonatti GreyDiscovery 3

Check joints and components from air filter to throttle body, sound like it’s taking in unregistered air
 Metal auto sump & fluid change (3 hrs)
LR door puddle projectors (10 mins)
Tinted Bonnet wind deflector (10 mins)
All Intercooler pipes and Tbolts (2hrs)
3 injectors replaced so far (30mins)
Sunroof drain pipes both sides 2.5 hrs)
Rear discs, shoes,pads,callipers,flexi hoses, rigid brake line, n/s upper hub carrier bush and rear n/s upper arm (13hrs over 2 days) 
 
Post #210582913th Dec 2019 9:24 pm
View user's profile Send private message View poster's gallery Reply with quote
Jacornel
 


Member Since: 12 Dec 2019
Location: Holland
Posts: 13

Netherlands 2008 Discovery 3 TDV6 SE Auto Unknown ColourDiscovery 3

Thank you for the replies.

I visually checked the inlet system from airfilter all the way to the throttle body. Didn’t find anything. I did not open it up to see the inside of the throttle body because the car is going in for service next week anyway. I’ll have it checked and will report the cause and solution.

Jim
  
Post #210595614th Dec 2019 2:15 pm
View user's profile Send private message View poster's gallery Reply with quote
Gareth
Site Moderator 


Member Since: 07 Dec 2004
Location: Bramhall
Posts: 26774

United Kingdom 

Diesel or V8? If it’s diesel the engine speed is governed electronically via the fuelling. There is no throttle as such. Could be a faulty accelerator pedal.
  
Post #210596614th Dec 2019 2:48 pm
View user's profile Send private message View poster's gallery Reply with quote
Jacornel
 


Member Since: 12 Dec 2019
Location: Holland
Posts: 13

Netherlands 2008 Discovery 3 TDV6 SE Auto Unknown ColourDiscovery 3

So i brought the car in for service this morning.

Just before i got there the car went into limp mode again and the mechanic hooked up the computer right away.

Only one real fault code which had something to do with the DPF. Message was something like "DPF pressure differential to high bank 1"

This time restarting didn't delete the fault, so guess i was there just in time. The mechanic said he would first try to regenerate the DPF and check it for leaks or faulty sensors. As the car wil be in for two days (timing belt and oilpump, full service, gearbox flush, diffs an tc oil change etc.) i will be back in a few days if the problem is solved.
  
Post #210664717th Dec 2019 9:33 am
View user's profile Send private message View poster's gallery Reply with quote
Irwin
 


Member Since: 04 Aug 2015
Location: Internet
Posts: 270


Mine is the same. Only notice it in first gear moving slowly. Keeps going for a few seconds after taking foot off throttle. I have no error messages or dpf. Egrs blanked. It feels like it’s holding on to change into second gear before it cuts off throttle. Interested to see if you find out anything.
  
Post #210679217th Dec 2019 6:56 pm
View user's profile Send private message View poster's gallery Reply with quote
Jacornel
 


Member Since: 12 Dec 2019
Location: Holland
Posts: 13

Netherlands 2008 Discovery 3 TDV6 SE Auto Unknown ColourDiscovery 3

So, the car is finally back from the specialist

They had holiday closings for two weeks and the car had some weird faults the day they were finished and test driving it.

They thought it was a dirty\faulty airpressure sensor in the throttle body. But guess what? A full service en cleaning the inlet/sensor didn't do the trick. The problem is still there. No limp mode yet, but i didn't drive in traffic yet so we'll experience soon i guess.

I really want this problem gone, so will keep trying to figure it out.
  
Post #21114588th Jan 2020 8:38 am
View user's profile Send private message View poster's gallery Reply with quote
gstuart
 


Member Since: 21 Oct 2016
Location: kent
Posts: 14129

United Kingdom 2005 Discovery 3 TDV6 Base 7 Seat Auto Java BlackDiscovery 3

Hi

Could a dirty MAP sensor ever cause this ??

ref Gareth mentioning the accelerator position sensors would it be worth looking on the gaps iid live data and watching there position, don’t know if it would work with just the ign on and pressing the pedal on and off

Does it still do it in sport mode
   
Post #21114788th Jan 2020 10:01 am
View user's profile Send private message View poster's gallery Reply with quote
Jacornel
 


Member Since: 12 Dec 2019
Location: Holland
Posts: 13

Netherlands 2008 Discovery 3 TDV6 SE Auto Unknown ColourDiscovery 3

Hi,

I found several other treats with same problems where the oil temp sensor was the cause. Will deffinetely go back to let them check all live data.

If the pedal would be the problem i guess it would be the same problem all the time and it would not give any limp mode or other system faults, because then the system simply thinks i’m applying a bit of throttle?
  
Post #21114828th Jan 2020 10:18 am
View user's profile Send private message View poster's gallery Reply with quote
Irwin
 


Member Since: 04 Aug 2015
Location: Internet
Posts: 270


On mine it only happens in gear. It doesn’t go into limp mode. Once it’s in gear in any D R S +/- modes and you reach 1500rpm it will keep going for a few seconds. In neutral the engine responds normally.
  
Post #21114998th Jan 2020 11:49 am
View user's profile Send private message View poster's gallery Reply with quote
J.Prezes
 


Member Since: 10 May 2015
Location: usually at my Indy's shop
Posts: 62

Poland 2008 Discovery 3 TDV6 HSE Auto Tonga GreenDiscovery 3

My is similar to Irwin's. In first and maybe second on low RPMs after you let go of the throttle it keeps revs for 2-3 seconds
  
Post #21115528th Jan 2020 4:15 pm
View user's profile Send private message View poster's gallery Reply with quote
Jacornel
 


Member Since: 12 Dec 2019
Location: Holland
Posts: 13

Netherlands 2008 Discovery 3 TDV6 SE Auto Unknown ColourDiscovery 3

So, brought the car in to the shop again yesterday after it fell into limp mode again. We took a look at some live data and the egr valves seem to not close fast enough after releasing the pedal. They stay at 42% for a few seconds before dropping down to 5%. They are now trying an egr and inlet cleaning process with some kind of MotoVac cleaning machine. Lets hope this will solve the problem. But as Irwin’s car has the same problems with blanked egr’s I’m a bit worried that it will not be over yet....
  
Post #211328416th Jan 2020 12:47 pm
View user's profile Send private message View poster's gallery Reply with quote
Jacornel
 


Member Since: 12 Dec 2019
Location: Holland
Posts: 13

Netherlands 2008 Discovery 3 TDV6 SE Auto Unknown ColourDiscovery 3

ok, small update.

They changed a speed sensor on the transfer case. problem was gone for about a day, or basically just on long drive home. next day problem was back, not all the time, but after a week its even worse than it was before. now it even sticks to 2000rpm in 2nd gear, which is kinda dangerous sometimes.

will bring the car in again to have it tested and readout some live data. I want this problem gone!
  
Post #211613627th Jan 2020 1:42 pm
View user's profile Send private message View poster's gallery Reply with quote
richw2000
 


Member Since: 15 Nov 2011
Location: Auckland
Posts: 58

New Zealand 2008 Discovery 3 TDV6 HSE Auto Tangiers OrangeDiscovery 3

Reopening this thread to see if it was resolved.
I had a new torque converter fitted a while back and it has started doing this along with a slight noise accompanying the delayed throttle release.
I think it has to be related to the torque converter so bringing it up here to see if it helps.
  
Post #21590805th Jul 2020 10:05 pm
View user's profile Send private message View poster's gallery Reply with quote
Display posts from the last:  
Post Reply Back to top
Page 1 of 2 12>
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site