Member Since: 04 May 2007
Location: Barcelona
Posts: 4317
Are you talking about the whole bumper, or just the black plastic/unpainted corners?
The bumper is a one piece jobby - they just mask the outer corners before painting....I'm just mentioning it in case you wanted to just replace the side parts which is how I understand your message...
If you want the whole thing, then ignore everything I've just said 2006 Discovery 3 TDV6 SE AutoBuckingham Blue 2007 Golf GT DSG
10th Nov 2009 5:41 pm
Dazza
Member Since: 01 Oct 2007
Location: North Kent
Posts: 34
Thanks Wiggs and PaulP for your reply.
It is just the plastic corner bits i need. I take it this means i have to buy the whole front bumper.
Are the bumpers easy to fit for the aveage DIY'er
11th Nov 2009 5:38 am
tanters
Member Since: 24 Oct 2007
Location: Oireland
Posts: 4286
Yeah, they are fairly easy Daz
you'll have to remove the lights (easy - 1 tab to pull up) and the front grille (easier- a few clips) and I think the front scoop underneath (easypesie - a few i turn toggles)
Few screws on top where the lights and grille come out, 4 underneath I think and then there are two screws on the inside on the wings holding the wheel arches which you undo along with two you'll see directly infront of the two wheels at the bottom of the arches. once they are out you can hold back the wheel arches and reveal one more bolt holding on the top corner of the bumper on either side. It should slide out then.
Edit: just do in reverse to fit
Shout if you're stuck A happy childhood ... is the worst possible preparation for life.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum