|
|
flydive
Member Since: 21 Aug 2007
Location: Lugano
Posts: 1535
|
Ok guys,
I just spent few interesting hours translating the operating manual from German to English
German being only my 4th language and not the best I tell you......
Also exporting from PDF to DOC to be able to work with it, messed up the formatting, so it was loads of fun 
Anyway now it is done and I think it came out ok, sent it to Danhag.
I might post it here too
I will tackle the installation instructions tomorrow
|
 20th Dec 2010 8:41 pm |
|
|
bluebarchetta
Member Since: 25 Oct 2005
Location: Aylesbury
Posts: 524
  
|
Thank you 
|
| 20th Dec 2010 9:39 pm |
|
|
Martin
Site Admin and Owner
Member Since: 06 Nov 2004
Location: Hook Norton
Posts: 18563
|
Good work, thanks  06 D3 SE / 15 LR D90 XS SW / 88 LR 90 Td5 / 68 BMW 2000 ti
Any issues with the site let me know!
|
| 20th Dec 2010 9:45 pm |
|
|
|
|
flydive
Member Since: 21 Aug 2007
Location: Lugano
Posts: 1535
|
VA, this is a job that cannot be done wearing white jeans 
Install guide done too.
Guys, you so much own me beers, plenty of them
|
| 20th Dec 2010 10:50 pm |
|
|
Ceekay
Member Since: 17 May 2009
Location: Bury
Posts: 2089
 
|
Thanks Flydive
Its much appreciated!
Just think you will be that familiar with all the tech details that you might as well go on a tour installing them for us
Cheers Ceekay D4 HSE Lux MY16 Club Waitomo
D3 HSE MY06 missing her still…
|
| 20th Dec 2010 11:06 pm |
|
|
|
|
arhrrs
Member Since: 08 Dec 2010
Location: west midlands
Posts: 34
|
Will we get a confirmation that our orders have been sent and perhaps a Tracking number so that we can check when it is due to arrive, as we are working shorter hours at my delivery address due to the weather.
|
| 22nd Dec 2010 11:20 am |
|
|
ajmooseman
Member Since: 03 Jun 2010
Location: Holmfirth
Posts: 13
|
just registered my intrest at the top of the page. What's next?? Do I get PM with details?
|
| 22nd Dec 2010 1:37 pm |
|
|
flydive
Member Since: 21 Aug 2007
Location: Lugano
Posts: 1535
|
| Re: Delivery Confirmation |
|
arhrrs wrote:Will we get a confirmation that our orders have been sent and perhaps a Tracking number so that we can check when it is due to arrive, as we are working shorter hours at my delivery address due to the weather.
Latest info as this evening.
The kit have been shipped, we should receive an email with tracking number from the shipping company.
|
| 22nd Dec 2010 9:56 pm |
|
|
ottoetrudy
Member Since: 20 Feb 2010
Location: forte dei marmi
Posts: 12
 
|
ho pagato anche io
otto
|
| 22nd Dec 2010 9:59 pm |
|
|
flydive
Member Since: 21 Aug 2007
Location: Lugano
Posts: 1535
|
Ok, just received a mail with the tracking link.
Look for a mail from hermes-europe.de
|
| 22nd Dec 2010 10:45 pm |
|
|
joachimen
Member Since: 17 Dec 2010
Location: Oslo
Posts: 1
 
|
| Danhag GSM controller + HVAC module |
|
Hi, new to the forum and I am impressed by the amount of information and variety of postings - it's a goldmine  . I am now the proud owner of a Disco3 for the second time but it's a chilling minus 22 here i norway and my FBH is not working. I've signed up for the group buy and was curious as to how the group buy works with regard to payment, shipping etc. I'm posting this reply as I have yet to earn the right to pm members directly if understand the rules that have been laid ut. Thank you Flydive for the initiatve and please excuse me if my posting should have been done differently.
|
| 23rd Dec 2010 9:22 am |
|
|
danhag
Member Since: 27 Nov 2010
Location: berlin
Posts: 19
|
The first devices are delivered.
There are occur repeatedly the same problems during the installation, so i would like to give some more details.
1.) the FBH won't start.
The most common cause is an empty battery. We had the same problem as we let the doors open and the indoor-lights on during the installation.
To delete any error stored by the heater itself, remove the fuse or the power suppy of the FBH for about 1 minute.
Please connect a battery charger for at least 1/2 hour and try again.
Please check the wiring. Is the yellow cable of the cable-harness properly connected to PIN2 of the heater ?
Is the output-signal of the GSM-remote control set to "W-Bus" ?
The LED of the GSM-remote control should flash green every second. As soon as you call the GSM-Remote, the LED should stay green.
If the LED turns to permanent red, it indicates an failure of the communication between the heater and the GSM-remote.
2.) The "Master mobile" gets a dialling tone but the GSM-Remote won't switch.
Please ensure that the "Master mobile" sends its own number (caller id).
Please check that the "Master" number is stored only once at the SIM-Card of the GSM-Remote control.
If you use an used SIM-card, please delete all numbers befor inserting into the GSM-remote control and programming via SMS.
3.) The heater blower won't start.
You can vary the speed of the heater-blower by turning the potentiometer on the heater-blower-control-box.
Please try to change the value by turning the adjusting screw carefully.
Note, the heater blower will only work when the GSM-remote control is switched on and the heater-blower delay time is expired.
(to test the system you can disconnect the 8pin connector from the GSM-remote control and connect pin3 (red) to pin1 (black) by using a small wire or paper clip)
If there are any questions or problems left, please don't hesitate to contact us via e-mail. We will try to answer as soon as possible.
daniel
|
| 23rd Dec 2010 3:31 pm |
|
|
Very Annoyed
Member Since: 19 Nov 2005
Location: Up there, past the strange people and the sheep.
Posts: 3698
|
Has everyone else received the email as I have yet to get confirmation of shipping? Loving the power of the TDV8!
|
| 24th Dec 2010 12:18 pm |
|
|
