Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset See It Here
15th Oct 2011 6:54 am
Hanechdene
Member Since: 23 Jun 2009
Location: High Wycombe
Posts: 570
When I changed the upper rear wishbone a couple of weeks ago I ended up cutting through the larger upper bush bolt (Land Rover do this up to 275lb). The bolt that goes through the knuckle I ended up drilling the head off as it had seized in the bush spigot. Then winded the nut on thereby drawing the remains of the bolt through. I used three 16 mm nuts as spacers as this bolt is not threaded all the way along. The head of this bolt is bloody hard so be ready to keep sharpening the drill bits. I was told by TFC to start small going up to 12 mm. There is a dimple in the head of the bolt to centre the drill on. Hope this helps, good luck!
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum