kenso
Member Since: 29 Aug 2006
Location: NSW
Posts: 111
  
|
Just had a new one happen... driving to work I could hear a clunking noise coming from the rear right wheel, pulled over expecting something like a shredding tyre... the tires were all ok.. Thought I must have been hearing things. The noise continued so I stopped got right under the rear axle and noticed that the brake line to the wheel had come out of the hook holder and was rubbing against the wheel; the rubber had worn away right down to the steel cover! the wear mark was about 2" long!  . I think I might put a cable tie on them all to stop this happening again! Suggest you all check yours to make sure they are firmly in the holders! I was lucky to get it in time, had it happened on the open road I think it would have worn through instantly.
Cheers
Kenso
|
 19th Jan 2007 3:50 am |
|
|
White Disco
Member Since: 15 Jan 2007
Location: Gondwana. It's raining. We'll All be roon'd.
Posts: 1463
|
Hi Kenso,
Good on Ya. Now I'm all paranoid 'bout the truck. Just been over with a fine tooth comb and looks OK. Thanks for the tip. My brake line runs through a flange after the clip and before going to a flexible hose section and on to the cylinder. Maybe a different set up to yours? The line would have to break through the steel flange before it could touch the wheel.
Cheers
David. Did you think I would leave you crying,
When there's room in my D3 for 7,
Climb in here Joe we'll soon be flying,
I can go just as fast with 7.
2005 TDV6 S with Terrain Response (& all that entails), Tasmods (gorn). 2008 TDV6 HSE (gone). A Dark Side umbrella (here) & car (here).
Volkswagen Golf (SWMBO's)
Datsun Insult (SWTSMBOBIO22SHOMSAH)
Datsun Insult (SWTSMBOBIO19SHOMSAH)
4 BMW's (Stents, not the silly cars)
Formerly RED DISCO
|
| 19th Jan 2007 4:20 am |
|
|
